Cisco Systems 7100 Series quick start Ok?

Start the System (continued)

	Last reset from power-on
	X.25 software, Version 3.0.0.
	2 FastEthernet/IEEE 802.3 interface(s)
	2 ATM network interface(s)
	125K bytes of non-volatile configuration			memory.
	8192K bytes of Flash PCMCIA card at slot			1 (Sector size 128K).
	8192K bytes of Flash internal SIMM (Sector size 256K).
2	Enter yes or press Return to enter the initial configuration dialog:
	--- System Configuration Dialog ---
	Would you like to enter the initial configuration dialog? [yes/no]: yes
	At any point you may enter a question mark '?' for help.
	Use ctrl-c to abort configuration dialog			at any prompt.
	Default settings are in square brackets '[]'.
	Basic management setup configures only enough connectivity
	for management of the system, extended setup will ask you
	to configure each interface on the system
3	Enter yes or press Return to see the current interface summary:
	First, would you like to see the current			interface summary? [yes]: yes
	Any interface listed with OK? value “NO”			does not have a valid configuration
	Interface	IP-Address	OK?	Method	Status	Protocol
	FastEthernet0/0	unassigned	NO	unset	up	up
	FastEthernet0/1	unassigned	NO	unset	up	up
	ATM1/0	unassigned	NO	unset	down	down
	ATM2/0	unassigned	NO	unset	down	down

Note: The example shows a router at first-time startup; that is, nothing is configured. The type of interfaces vary depending on the type of Cisco 7100 series router you are using and the type of modular port adapter installed in the router.

17