Cisco Systems 340, 350 manual Installation Connecting the Ethernet and Power Cables

Chapter 2 Installation

Connecting the Ethernet and Power Cables

Step 3 Connect the other end of the Ethernet cable to the device that will supply power.

If you use a power injector, follow these additional steps:

a.Plug the cable from the access point into the end of the power injector labeled To AP/Bridge.

b.Run an Ethernet cable from the end of the power injector labeled To Network to the 10/100 Ethernet switch.

c.Plug the female end of the power cord into the universal power supply.

d.Plug the male end of the power cord into a power outlet or power strip.

At start-up, all three LEDs on the top of the access point slowly blink amber, red, and green in sequence; the sequence takes a few minutes to complete. During normal operation, the LEDs blink green. Refer to Chapter 4, “Troubleshooting,” for LED descriptions.

Step 4 Follow the steps in Chapter 3, “Basic Configuration,” to assign basic settings to the access point.

Cisco Aironet Access Point Hardware Installation Guide

OL-0738-02 2-9