![](/images/new-backgrounds/1174466/17446693x1.webp)
Chapter 4 Troubleshooting
Resetting to the Default Configuration
Step 10 After the access point reboots and the Express Setup screen appears, reconfigure the access point by using the terminal emulator or an Internet browser.
Steps for Firmware Versions 11.06 or Earlier
Follow the steps in this section if your access point is running firmware version 11.06 or earlier.
Note The following steps reset all configuration settings to factory defaults, including passwords, WEP keys, the IP address, and the SSID. If you do not need to reset the entire configuration, use the Configuration Reset buttons on the System Configuration Setup page in the
Determining the Boot-Block Version
The steps you follow to reconfigure the access point depend on the version of the access point’s boot block. Follow these steps to find out which boot block version is on your access point:
Step 1 Open a Telnet session to the access point.
Note You can also use these instructions while communicating with the access point through the console port or with an SNMP manager. Skip to Step 3 if you use an SNMP manager.
Step 2 Type :cmd and press Enter to switch from
Step 3 Type bootblockVersion and press Enter. Text appears with information about the system. If your access point’s boot block version is 1.01, the text might look like this:
OID: iso.org.dod.internet.private.enterprises.aironet.awcVx.awcSystem. bootblockVersion
Value [RO]: 1.01
Step 4 Type exit and press Enter to return to
Step 5 If your boot block version is 1.01 or earlier, follow the instructions in the “Reconfiguration Steps for Boot Block Version 1.01 or Earlier” section on page
Cisco Aironet Access Point Hardware Installation Guide
|
| ||
|
|