Chapter 3 Installing the Cisco 7609 Internet Router
Attaching the Interface Cables
Connecting the Supervisor Engine Uplink Ports
This section describes how to connect to the supervisor engine uplink ports.
Warning Because invisible laser radiation may be emitted from the aperture of the port when no cable is connected, avoid exposure to laser radiation and do not stare into open apertures.
Note In a redundant configuration with two supervisor engines, the uplink ports on the redundant (standby) supervisor engine are active and can be used for normal traffic, like any other ports in the chassis.
To connect to the supervisor engine uplink ports, perform these steps:
Step 1 Remove the plugs from the Gigabit Interface Converter (GBIC) optical bores; store them for future use.
Step 2 Remove the plugs from the
Figure 3-8 Connecting the Supervisor Engine Uplink Ports
PORT 1
LINK
48128
| Cisco 7609 Internet Router Installation Guide |
|