Chapter 5 Removal and Replacement Procedures
Removing and Replacing the Power Supply
Step 8 Turn the power switch to the On () position on the power supply. Switching the power switch to On also engages a pawl that locks the power supply in the bay.
Step 9 Verify power supply operation by checking that the power supply front panel LEDs are in the following states:
•INPUT OK LED is green
•FAN OK LED is green
•OUTPUT FAIL LED is not lit
If the LEDs indicate a power problem, see the “Identifying Startup Problems” section on page
Removing a DC-Input Power Supply
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the circuit breaker in the OFF position.
Warning Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock, keep hands and fingers out of the power supply bays and backplane areas.
Follow these steps to remove a
Step 1 Verify that power is off to the DC circuit on the power supply you are removing.
Step 2 Turn the power switch to the Off (0) position on the power supply you are removing. (See Figure
Step 3 Remove the two screws securing the terminal block cover, and slide the cover off the terminal block. (See Figure
| Cisco 7609 Internet Router Installation Guide |
|