lane config database test
Tintin
lane database test
name ilmi−test server−atm−address 47.00918100000000603E5A4501.00603E5A4503.01
!
interface ATM2/0/0 no ip address
no ip directed−broadcast logging event subif−link−status
lane config fixed−config−atm−address
lane config database test
With this new configuration, a LECS has been configured on Bernard and Casimir, and no LECS address database has been configured on Casimir. This means that SSRP is not enabled. To illustrate the error message, the Bernard atm 2/0/0 interface is shut down before it is configured, and the Casimir configuration is modified first. In this situation, Casimir advertises the well−known address via ILMI, thus preventing Bernard from doing so. As soon as the Bernard atm 2/0/0 interface is brought up, this message is displayed:
1w2d: %LANE−3−NOREGILMI: ATM2/0/0 LECS cannot register 47.007900000000000000000000.00A03E000001.00 with ILMI
Configuration Problems
Another possible cause of failure of the address registration is a problem with the configuration on the LightStream 1010.
interface ATM0/0/0
no ip address
no ip directed−broadcast
logging event subif−link−status
atm ilmi−keepalive
no atm address−registration
The command above prevents any address registration via ILMI which, in this case, prevents the router from receiving its prefix, and thus also advertising its address to the switch:
bernard# show lane default−atm−addresses interface atm 2/0/0
LANE Client: | ...000000000002.** | |
LANE Server: | ...000000000003.** | |
LANE Bus: |
| ...000000000004.** |
LANE Config | Server: ...000000000005.00 | |
note: ** is | the subinterface number byte in hex | |
bernard# show atm ilmi−status atm 2/0/0
Interface : ATM2/0/0 Interface Type : Private UNI (User−side)
ILMI VCC : (0, 16) ILMI Keepalive : Disabled |
| ||
ILMI State: | UpAndNormal |
|
|
Peer IP Addr: | 10.200.10.12 | Peer IF Name: | ATM0/0/0 |
Peer MaxVPIbits: | 8 | Peer MaxVCIbits: | 14 |
Cisco − ILMI Address Registration Problems: %LANE−3−NOREGILMI