Casimir# show atm vc traffic interface atm 0/0/0 0 16
Interface | VPI | VCI | Type | rx−cell−cnts | tx−cell−cnts |
ATM0/0/0 | 0 | 16 | PVC | 308 | 316 |
If you see only the sent or received counter incrementing, it may means that cells are being stuck on the backplane causing ILMI to be stuck. Try issuing a shut/no shut command on the interface. If that does not help, contact Cisco Technical Support for further troubleshooting. If both counters are incrementing, then the ILMI PVC is transmitting cells properly.
Known Caveats
There are also some known bugs which can explain why ILMI is not coming up properly. These are Cisco Bug IDs CSCdt47492, CSCdm26756 and CSCdr28332.
To follow the bug ID link below and see detailed bug information, you must be a user and you must be .
The rest of this document assumes that the ILMI PVC is UP and carrying cells and that the ILMI status is correct on all the devices. Then, the possible causes for address registration failures via ILMI are:
∙The switch already knows the NSAP address
∙Configuration problem
If the Switch Knows the NSAP Address
These are scenarios in which the switch already knows the NSAP address.
When the NSAP Address Is Configured Statically on the Switch
On the router Bernard, you can see this message:
1w1d: %LANE−3−NOREGILMI: ATM2/0/0.1 LEC cannot register 47.00918100000000603E5A4501.00D0069A7C40.01 with ILMI
When looking on the switch for the NSAP address 47.00918100000000603E5A4501.00D0069A7C40.01, you can see this information:
Casimir# show atm route 47.0091.8100.0000.0060.3e5a.4501.00d0.069a.7c40.01 Codes: I − internal prefix, E − exterior prefix
E47.0091.8100.0000.0060.3e5a.4501.00d0.069a.7c40/152
Advertised in PTSE ID 3 IG IX 0 by node−index 1
Node 1: Port ATM0/0/3, by atm−static, 00:00:39, uni scope 15 adv_trig 0x2, src_mask 0x1, node−index 0, rtaddr_index 1
Casimir# show atm route
Codes: P − installing Protocol (S − Static, P − PNNI, R − Routing control), T − Type (I − Internal prefix, E − Exterior prefix, SE −
Summary Exterior prefix, SI − Summary Internal prefix,
ZE − Suppress Summary Exterior, ZI − Suppress Summary Internal)
P | T | Node/Port | St Lev | Prefix | ||
~ ~~ | ~~~~~~~~~~~~~~~~ | ~~ ~~~ | ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ | |||
P | I | 9 | 0 | UP 0 | 47.0091.8100.0000.0010.1f2d.6801/104 | |
P SI | 1 | 0 | UP | 0 | 47.0091.8100.0000.0060.3e5a.4501/104 | |
R | I | 1 | ATM0/0/3 | UP | 0 | 47.0091.8100.0000.0060.3e5a.4501.0000.0c0e.09e7/152 |
Cisco − ILMI Address Registration Problems: %LANE−3−NOREGILMI