Cisco Systems AIR-CT2504-5-K9, 2500 manual Mounting Screw Holes on the Back of the Controller

Page 16

Warning

Read the wall-mounting carefully before beginning installation. Failure to use the

 

correct hardware or to follow the correct procedures could result in a hazardous

 

situation to people and damage to the system. Statement 378

 

 

To mount the controller on a wall using mounting screws, follow these steps:

Step 1 Mark the location of the mounting screws on the wall. Use the mount hole locations on the back of the controller for placement of the mounting screws (Figure 7). (The mount holes are shown in Figure 7 with a cross-hatch mark.)

Figure 7 Mounting Screw Holes on the Back of the Controller

5.5

3.9

FRONT PANEL

282087

Step 2 Use a 0.107-inch (2.7mm) or #32 drill bit to drill a 3/4 inch (19mm) hole for the two mounting screws.

Step 3 Insert two screws into the screw holes and tighten until the top of the screws are 1/8 inch from the wall (leaving enough room for the back panel to slide onto the screws firmly).

16

Image 16
Contents Cisco 2500 Series Wireless Controller FCC Safety Compliance Statement Safety InformationSuitable grounding is available. Statement Introduction to the ControllerRegulations. Statement Typical Controller Topology and Network Connections Callout Port and LEDs State and Description ConsoleGreen or Blinking Green-Link activity Reset Power 48VDC Ports and Slots State and DescriptionPackage Contents Required Tools and InformationInitial System Configuration Information Choosing a Physical Location Mounting the ControllerMounting the Controller on a Desktop or Shelf Mounting the Controller on a Wall Rack-Mount Brackets Situation to people and damage to the system. StatementBase Mount Mounting the Controller on a Wall Mounting Screws Mounting Screw Holes on the Back of the Controller Place the Controller on the Mounting Screws Top with the heaviest component at the bottom of the rack Are provided to ensure your safetyOr servicing the unit in the rack. Statement Attaching the 19-Inch Brackets to the Side of the Controller Mounting the Controller in a 19-Inch Rack Connecting the Controller Console Port Securing the Power Adapter CablePlastic Relief Clip Running the Bootup Script and Power-On Self Test Installing a Security LockCisco Systems Page License Agent ok Cisco Controller Loading primary image 7.0.114.76 100% Page Using the Startup Wizard License Agent okWizard Setting Action Requires a Radius server. Please see Wizard Setting Action Logging into the Controller Connecting to the Network Connecting Access Points Using the Reset Button Checking the Controller LEDsWhat’s New in Cisco Product Documentation Waarschuwing Belangrijke Veiligheidsinstructies Statement 1071-Warning DefinitionVaroitus Tärkeitä Turvallisuusohjeita Warnung Wichtige Sicherheitshinweise Avvertenza Importanti Istruzioni Sulla SicurezzaTA Vare PÅ Disse Instruksjonene Aviso Instruções Importantes DE SegurançaVarning! Viktiga Säkerhetsanvisningar Page Page Page Page Page Statement 1015-Battery Handling Page Statement 1024-Ground Conductor Page Page Statement 1040-Product Disposal Page Page Statement 371-Power Cable and AC Adapter Statement 157-VCCI Compliance for Class B Equipment