Cisco Systems 2500, AIR-CT2504-5-K9 manual Wizard Setting Action

Table 3	Startup Wizard Information (continued)
Wizard Setting		Action
Allow Static IP Addresses			Enter YES to allow clients to assign their own IP
			address or no to make clients request an IP
			address from a DHCP server. Values are YES or
			no. The default setting is YES.
Configure a RADIUS Server Now?			If you select YES, you are prompted to enter the
			following:
			• RADIUS server IP address
			• RADIUS server port (default port is 1812)
			• RADIUS server secret
			If you select no, the following message appears:
			Warning! The default WLAN security policy
			requires a RADIUS server. Please see
			documentation for more details.
Enter Country Code List			Enter the two letter country code. The default
			country code is the United States (US). Enter
			‘help’ to see a list of countries.
Enable 802.11b Network			Choose YES to enable or no to disable the
			802.11b radio network. The default is YES.
Enable 802.11a Network			Choose YES to enable or no to disable the
			802.11a radio network. The default is YES.
Enable 802.11g Network			Choose YES to enable or no disable the 802.11g
			radio network. The default is YES.
Enable Auto-RF			Choose YES to enable or no to disable radio
			resource management. The default is YES.
Configure a NTP server now?			Enter YES to configure an NTP server. The values
			are YES or no. The default value is YES.
Enter the NTP server IP address			Enter the NTP server IP address.
			Note	This prompt only displays if YES was
				entered in the “Configure a NTP Server
				Now?” prompt.

32