Important Information
Note The Cisco XR 12000 Series Routers must have a full set of switch fabric cards installed to support the requirements of the Ethernet line cards. See the appropriate Cisco 12000 Series Router installation guide for information about the switch fabric and other related requirements.
Note Because the
Cisco IOS Software Release and Hardware Revision Requirements
The Ethernet line cards have certain Cisco IOS software requirements. Also, to ensure compatibility with the software, your Ethernet line card should have a specific hardware revision number. The number is printed on a label affixed to the component side of the card and is displayed by the show diag command.
Table 3 lists the hardware and software requirements for Ethernet line cards.
Table 3 Ethernet Line Card and Cisco IOS Release and Hardware Version Compatibility
| Line Card |
| Required |
Ethernet Line Card | Part Number | Minimum IOS Software Release | Hardware Version |
|
|
|
|
Cisco IOS Release 12.0(25)S or later | |||
Ethernet ISE |
|
|
|
|
|
|
|
12.0(19)S or later release of 12.0S; or 12.0(19)ST or | |||
Ethernet |
| later release of 12.0ST |
|
|
|
|
|
| 12.0(21)S or later release of 12.0S; or 12.0(21)ST or | ||
|
| later release of 12.0ST |
|
|
|
|
|
12.0(23)S, or later, release of 12.0S1 | |||
Ethernet | (LR laser optical |
|
|
| transceiver) |
|
|
|
|
|
|
|
| 12.0(23)S, or later release of 12.0S | |
| (ER laser optical |
|
|
| transceiver) |
|
|
|
|
|
|
1. Cisco IOS Release 12.0(22)S does not support the
The show diag slot_number, show version, and show hardware commands display the current hardware configuration of the router, including the system software version that is currently loaded and running, and the hardware revision number. For complete descriptions of show commands, refer to the Cisco IOS Configuration Fundamentals Configuration Guide and the Cisco IOS Configuration Fundamentals Command Reference for the installed Cisco IOS release.
If the command displays indicate that the Cisco IOS software is a version earlier than you need, check the contents of flash memory to determine if the required images are available on your system. The dir devicename command displays a list of all files stored in flash memory. If you do not have the correct software version, contact Cisco customer service.
For software configuration information, refer to the Cisco IOS software configuration and command reference publications for the installed Cisco IOS release. Also refer to the Cisco IOS software release notes for additional information.
Cisco XR 12000 Series Router Ethernet Line Card Installation
| 3 |
| |
|
|