Cisco Systems 10008 quick start Removing the Safety Cover

Page 27

Figure 19 Removing the Safety Cover

30023

Step 2 Remove the safety cover by lifting it up and out from the chassis.

Figure 20 Stripping Insulation

10 mm max

14747

Step 3 Using a wire-stripping tool, strip not more than 0.4 inches (10 mm) of insulation off the ends of the alarm indicator wire.

27

Image 27

Contents Cisco 10008 Router Obtaining Documentation Documentation and ResourcesDocument Version History Documentation Survey Related DocumentationDocumentation Feedback Product Documentation DVDOrdering Documentation Reporting Security Problems in Cisco Products Cisco Product Security OverviewObtaining Technical Assistance Submitting a Service Request Definitions of Service Request SeverityCisco Technical Support & Documentation Website Obtaining Additional Publications and Information Quantity Description Comments Preparing for InstallationSite Preparation Recommended Tools and SuppliesInstalling the Router Lifting the Chassis Lifting the ChassisRack-Mounting the Router in a 19-Inch 4-Post Rack Power Fault Miswire30012 Attaches the chassis to the rack StepAution Rack-Mounting the Router in a 23-Inch 2-Post Rack30014 30015 Attaching the Cable-Management Bracket Attaching the Cable-Management BracketAttaching the Grounding Lug Attaching Grounding Wire to Grounding LugSuitable grounding is available. Statement Installing Line CardsConnecting Power Connecting DC Power to the Cisco 10008 RouterOr weld the metal object to the terminals. Statement Set the DC PEM switches to the Off position Removing the Safety Cover DC Power Connections Securing DC Power Cables to the Chassis Connecting AC Power to the Cisco 10008 RouterSetting AC PEM Switches to the Off Position AC Power Cord Connectors in Strain-Relief Devices Connecting Alarm Indicators Connecting CablesRemoving the Safety Cover Alarm Indicator Terminal Block Connections Alarm Indicator Wires Exiting the Safety Cover Connecting a Video Terminal to the PRE Console PortConsole Port Connection on the PRE Ethernet Network Management Cable Connections Connecting Network Management and Signal System CablesConnecting to a 100BASE-T Ethernet Network Correctly connected to the 100BASE-T Ethernet LAN Auxiliary Modem Connection Installing Network Cables to the Line CardsPower Fault Miswire Powering On the SystemConfiguring the Cisco 10008 Router at Startup Basic Configuration Using the Setup FacilityStartup Display Basic System Configuration Procedure Using the System Configuration DialogSpecify the IP address Routerconfig # interface FastEthernet0/0/0 Basic Configuration in Global Configuration ModeRouter# format disk0 Formatting Flash Disks and Flash CardsManaging the File Systems File SystemsCLI Name Description Managing Configuration Files Larger than Nvram Compressing the Configuration FileRelocating the Configuration to a Flash Disk Exit global configuration mode Troubleshooting Installation Problems General Troubleshooting TipsSymptom Steps to Take Switch configure terminal Troubleshooting Ethernet ConnectionsTroubleshooting the Console Port Serial Connection Page USA