Cisco Systems 10008 quick start Correctly connected to the 100BASE-T Ethernet LAN

Page 33

The RJ-45 port on the PRE is configurable for 100-Mbps full-duplex or half-duplex operation (half-duplex is the default) and supports IEEE 802.3, Ethernet, and IEEE 802.3u interfaces compliant with 100BASE-T specifications.

Follow these steps to connect the PRE to a 100BASE-T Ethernet LAN:

Figure 26 Connecting the 100BASE-T Cable to the Ethernet Port

SLOT SLOT

0 1

CISCO 10000

CONSOLE

AUX

LINK

LINKETHERNET

	30036

Step 1	Connect one end of the Ethernet cable to the RJ-45 port on the primary PRE, labeled ETHERNET.
Step 2	Run the cable up and through the cable management bracket and connect the other end of the Ethernet cable to any
	unoccupied port on the Ethernet hub.
Step 3	Check the LINK LED on the PRE faceplate (next to the ETHERNET port). This LED lights (green) if the PRE is
	correctly connected to the 100BASE-T Ethernet LAN.

33

Image 33

Contents Cisco 10008 Router Document Version History Documentation and ResourcesDocumentation Survey Related Documentation Obtaining DocumentationDocumentation Feedback Product Documentation DVDOrdering Documentation Reporting Security Problems in Cisco Products Cisco Product Security OverviewObtaining Technical Assistance Submitting a Service Request Definitions of Service Request SeverityCisco Technical Support & Documentation Website Obtaining Additional Publications and Information Site Preparation Preparing for InstallationRecommended Tools and Supplies Quantity Description CommentsInstalling the Router Lifting the Chassis Lifting the ChassisRack-Mounting the Router in a 19-Inch 4-Post Rack Power Fault Miswire30012 Attaches the chassis to the rack StepAution Rack-Mounting the Router in a 23-Inch 2-Post Rack30014 30015 Attaching the Cable-Management Bracket Attaching the Cable-Management BracketAttaching the Grounding Lug Attaching Grounding Wire to Grounding LugSuitable grounding is available. Statement Installing Line CardsConnecting Power Connecting DC Power to the Cisco 10008 RouterOr weld the metal object to the terminals. Statement Set the DC PEM switches to the Off position Removing the Safety Cover DC Power Connections Securing DC Power Cables to the Chassis Connecting AC Power to the Cisco 10008 RouterSetting AC PEM Switches to the Off Position AC Power Cord Connectors in Strain-Relief Devices Connecting Alarm Indicators Connecting CablesRemoving the Safety Cover Alarm Indicator Terminal Block Connections Alarm Indicator Wires Exiting the Safety Cover Connecting a Video Terminal to the PRE Console PortConsole Port Connection on the PRE Ethernet Network Management Cable Connections Connecting Network Management and Signal System CablesConnecting to a 100BASE-T Ethernet Network Correctly connected to the 100BASE-T Ethernet LAN Auxiliary Modem Connection Installing Network Cables to the Line CardsPower Fault Miswire Powering On the SystemConfiguring the Cisco 10008 Router at Startup Basic Configuration Using the Setup FacilityStartup Display Basic System Configuration Procedure Using the System Configuration DialogSpecify the IP address Routerconfig # interface FastEthernet0/0/0 Basic Configuration in Global Configuration ModeRouter# format disk0 Formatting Flash Disks and Flash CardsManaging the File Systems File SystemsCLI Name Description Managing Configuration Files Larger than Nvram Compressing the Configuration FileRelocating the Configuration to a Flash Disk Exit global configuration mode Troubleshooting Installation Problems General Troubleshooting TipsSymptom Steps to Take Switch configure terminal Troubleshooting Ethernet ConnectionsTroubleshooting the Console Port Serial Connection Page USA