Cabletron Systems FOT-F3 user manual Introduction Related Manuals

Page 13

INTRODUCTION

1.4 RELATED MANUALS

The manuals identified below should be used to supplement the procedures and other technical data provided in this manual. The procedures contained in the manuals below will be referenced only.

Cabletron Systems’ LAN-MDPortable Ethernet Tester User’s Manual.

Cabletron Systems'FOMIM-32/36/38Fiber Optic Interface Module Installation Guide.

Page 1 - 8

Image 13

Contents FOT-F3 Fiber Optic Transceiver USER’S Manual Velcro is a registered trademark of Velcro Industries, B.V FCC Notice FCC NoticeContents Cont Testing and Using LanviewChapter Introduction Using this ManualGetting Help Connections FOT-F3 Fiber Optic TransceiverDistance and Cable Type Lanview LEDs Signal Quality Error SQE TestApplication FOT-F3 Setup, ExampleMmac Introduction Related Manuals REQUIREMENTS/SPECS Chapter Installation Requirements SpecificationsNetwork Design Guidelines Fiber Optic Requirements AUI Requirements Operating SpecificationsParameter Typical Minimum Maximum REQUIREMENTS/SPECS Fiber Optic InterfaceFiber Optic Interface AUI Pin Connections REQUIREMENTS/SPECS AUI ConnectorPWR Power REQUIREMENTS/SPECS IndicatorsSQE Signal test Quality Error Power Supply REQUIREMENTS/SPECS Environmental SafetyPhysical Installation Chapter Installing the FOT-F3Unpacking the FOT-F3 Setting the SQE Switch Connecting the FOT-F3 to the NetworkSQE Switch AUI Connection Connecting the AUI CableConnecting the Fiber Optic Cable Installation ST Fiber Optic Ports Connectors Mounting the FOT-F3 Cable Support Installation Installation Mounting the FOT-F3 Testing and Troubleshooting Chapter Testing and TroubleshootingInstallation CHECK-OUT Testing the Fiber Optic Link Segment Testing the FOT-F3 Fiber Optic Transceiver LAN-MD FOT-F3 Testing and Troubleshooting Optical Link OK LNK LED Testing and Troubleshooting Using LanviewCollision CLN LED Receive RCV LED Power PWR LED Signal Quality Error Test Function SQE LEDTransmit XMT LED