Cabletron Systems FOT-F3 user manual Velcro is a registered trademark of Velcro Industries, B.V

Page 2

NOTICE

NOTICE

Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

©Copyright October 1991 by:

Cabletron Systems, Inc.

P.O. Box 5005, Rochester, NH 03867-0505

All Rights Reserved

Printed in the United States of America

Order number: 9030461 Oct. 91

LANVIEW is a registered trademark of Cabletron Systems, Inc.

LAN-MD,FOT-F3, FOMIM-32/36/38,MMAC, and IRM are trademarks of Cabletron Systems, Inc.

Velcro is a registered trademark of Velcro Industries, B.V.

i

Image 2
Contents FOT-F3 Fiber Optic Transceiver USER’S Manual Velcro is a registered trademark of Velcro Industries, B.V FCC Notice FCC NoticeContents Testing and Using Lanview ContUsing this Manual Chapter IntroductionGetting Help FOT-F3 Fiber Optic Transceiver ConnectionsDistance and Cable Type Signal Quality Error SQE Test Lanview LEDsFOT-F3 Setup, Example ApplicationMmac Introduction Related Manuals Network Design Guidelines Chapter Installation Requirements SpecificationsREQUIREMENTS/SPECS Fiber Optic Requirements Operating Specifications AUI RequirementsREQUIREMENTS/SPECS Fiber Optic Interface Parameter Typical Minimum MaximumFiber Optic Interface REQUIREMENTS/SPECS AUI Connector AUI Pin ConnectionsSQE Signal test Quality Error REQUIREMENTS/SPECS IndicatorsPWR Power Power Supply Physical SafetyREQUIREMENTS/SPECS Environmental Unpacking the FOT-F3 Chapter Installing the FOT-F3Installation Connecting the FOT-F3 to the Network Setting the SQE SwitchSQE Switch Connecting the AUI Cable AUI ConnectionConnecting the Fiber Optic Cable Installation ST Fiber Optic Ports Connectors Mounting the FOT-F3 Cable Support Installation Installation Mounting the FOT-F3 Installation CHECK-OUT Chapter Testing and TroubleshootingTesting and Troubleshooting Testing the Fiber Optic Link Segment Testing the FOT-F3 Fiber Optic Transceiver LAN-MD FOT-F3 Testing and Troubleshooting Collision CLN LED Testing and Troubleshooting Using LanviewOptical Link OK LNK LED Receive RCV LED Transmit XMT LED Signal Quality Error Test Function SQE LEDPower PWR LED