Cabletron Systems FOT-F3 user manual Connecting the Fiber Optic Cable

INSTALLATION

If the PWR LED is not lit, perform the following steps:

a.Verify that the power is turned on for the device attached to the FOT-F3.

b.Disconnect the AUI from the FOT-F3.

c.Disconnect the device to which the transceiver is attached.

d.Check the AUI connections for proper pinouts. The pinouts for the transceiver connection are listed in Chapter 2.

e.Check the cable for continuity.

f.Reconnect the AUI cable to the FOT-F3 and the device.

3.Move the slide lock on the AUI connector to secure it to the lock posts on the port.

3.2.3 Connecting the Fiber Optic Cable

This section describes how to connect the fiber optic link segment to the FOT-F3. Perform the following steps only after testing the fiber optic cable to ensure that the cable has no defects.

Page 3 - 5