Cabletron Systems FOT-F3 user manual Fiber Optic Interface

Page 18

REQUIREMENTS/SPECS.

FIBER OPTIC INTERFACE (cont.)

 

Transmitter Peak 1300 nm

1270 nm

1330 nm

Wave Length

 

 

 

Spectral Width

60 nm

-

100 nm

Rise Time/

3.0 nsec

2.7 nsec

5.0 nsec

Fall Time

2.5 nsec

2.2 nsec

5.0 nsec

Duty Cycle

50.1%

49.6%

50.7%

Bit Error Rate: Better than 10-10bit error rate

NOTE: The transmitter power levels and receive sensitivity levels given above are Peak Power Levels after optical overshoot. You must use a Peak Power Meter to correctly compare the values given above to those measured on any particular port.

If you are measuring power levels with an Average Power Meter, add 3 dBm to the measurement to correctly compare those measured values to the values listed above (i.e. -30.5 dBm peak = -33.5 dBm average).

Page 2 - 5

Image 18
Contents FOT-F3 Fiber Optic Transceiver USER’S Manual Velcro is a registered trademark of Velcro Industries, B.V FCC Notice FCC NoticeContents Testing and Using Lanview ContUsing this Manual Chapter IntroductionGetting Help FOT-F3 Fiber Optic Transceiver ConnectionsDistance and Cable Type Signal Quality Error SQE Test Lanview LEDsFOT-F3 Setup, Example ApplicationMmac Introduction Related Manuals Chapter Installation Requirements Specifications REQUIREMENTS/SPECSNetwork Design Guidelines Fiber Optic Requirements Operating Specifications AUI RequirementsREQUIREMENTS/SPECS Fiber Optic Interface Parameter Typical Minimum MaximumFiber Optic Interface REQUIREMENTS/SPECS AUI Connector AUI Pin ConnectionsREQUIREMENTS/SPECS Indicators PWR PowerSQE Signal test Quality Error Power Supply Safety REQUIREMENTS/SPECS EnvironmentalPhysical Chapter Installing the FOT-F3 InstallationUnpacking the FOT-F3 Connecting the FOT-F3 to the Network Setting the SQE SwitchSQE Switch Connecting the AUI Cable AUI ConnectionConnecting the Fiber Optic Cable Installation ST Fiber Optic Ports Connectors Mounting the FOT-F3 Cable Support Installation Installation Mounting the FOT-F3 Chapter Testing and Troubleshooting Testing and TroubleshootingInstallation CHECK-OUT Testing the Fiber Optic Link Segment Testing the FOT-F3 Fiber Optic Transceiver LAN-MD FOT-F3 Testing and Troubleshooting Testing and Troubleshooting Using Lanview Optical Link OK LNK LEDCollision CLN LED Receive RCV LED Signal Quality Error Test Function SQE LED Power PWR LEDTransmit XMT LED