Cabletron Systems FOT-F3 user manual Cont, Testing and Using Lanview

Page 5

CONTENTS

CHAPTER 3 (Cont.)

3.3	Mounting the FOT-F3	3-8
3.4	Cable Support Installation	3-9
CHAPTER 4 TESTING AND USING LANVIEW
4.1	Installation Checkout	4-1
	4.1.1 Testing the Fiber Optic Link Segment	4-2
	4.1.2 Testing the FOT-F3
	Fiber Optic Transceiver	4-3
4.2	Using LANVIEW	4-6

iv

Image 5

Contents FOT-F3 Fiber Optic Transceiver USER’S Manual Velcro is a registered trademark of Velcro Industries, B.V FCC Notice FCC NoticeContents Cont Testing and Using LanviewChapter Introduction Using this ManualGetting Help Connections FOT-F3 Fiber Optic TransceiverDistance and Cable Type Lanview LEDs Signal Quality Error SQE TestApplication FOT-F3 Setup, ExampleMmac Introduction Related Manuals Network Design Guidelines Chapter Installation Requirements SpecificationsREQUIREMENTS/SPECS Fiber Optic Requirements AUI Requirements Operating SpecificationsParameter Typical Minimum Maximum REQUIREMENTS/SPECS Fiber Optic InterfaceFiber Optic Interface AUI Pin Connections REQUIREMENTS/SPECS AUI ConnectorSQE Signal test Quality Error REQUIREMENTS/SPECS IndicatorsPWR Power Power Supply Physical SafetyREQUIREMENTS/SPECS Environmental Unpacking the FOT-F3 Chapter Installing the FOT-F3Installation Setting the SQE Switch Connecting the FOT-F3 to the NetworkSQE Switch AUI Connection Connecting the AUI CableConnecting the Fiber Optic Cable Installation ST Fiber Optic Ports Connectors Mounting the FOT-F3 Cable Support Installation Installation Mounting the FOT-F3 Installation CHECK-OUT Chapter Testing and TroubleshootingTesting and Troubleshooting Testing the Fiber Optic Link Segment Testing the FOT-F3 Fiber Optic Transceiver LAN-MD FOT-F3 Testing and Troubleshooting Collision CLN LED Testing and Troubleshooting Using LanviewOptical Link OK LNK LED Receive RCV LED Transmit XMT LED Signal Quality Error Test Function SQE LEDPower PWR LED