Cabletron Systems FOT-F3 user manual Connecting the AUI Cable, AUI Connection

INSTALLATION

3.2.2 Connecting the AUI Cable

To connect your Ethernet device to the FOT-F3, attach an AUI cable as follows. See Figure 3-2.

1.Attach an AUI cable to the device to which the FOT-F3 will be connected.

2.Attach the female connector on the AUI cable to the AUI port on the FOT-F3. If the power is on for the Ethernet device, the PWR LED should be lit, indicating the transceiver is receiving power from the device. Also, the SQE LED should be lit, if the SQE test is enabled.

	Slide Latch
	AUI Port
A	AUI Connector
U
I

Figure 3-2. AUI Connection

Page 3 - 4