Cabletron Systems FDDI Repeater manual Installing the MicroLAN Module, Unpacking the Module

Page 11

Chapter 2

Installing the MicroLAN Module

This module uses FPIMs for the front panel connections. They are not shipped with the module and must be purchased separately. For more information on FPIMs see Appendix A.

Unpacking the Module

1.Carefully remove the module from the shipping box. (Save the box and packing materials in the event the module must be reshipped.)

2.Remove the module from the plastic bag. Observe all precautions to prevent damage from Electrostatic Discharge (ESD).

3.Carefully examine the module, checking for damage. If any damage exists, DO NOT install the module. Contact Cabletron Systems Technical Support immediately.

Installing an FPIM

FPIMs are required for the 9F206-02 and are ordered and shipped separately. To install an FPIM, follow the procedure below:

1.Remove the module if it is installed in the MMAC-Plus chassis.

2.Remove the blank front cover over the FPIM slot.

3.Install the FPIM as shown in Figure 2-1.Ensure that the rear connector is seated ﬁrmly before tightening the two mounting screws.

2-1

Image 11

Contents MMAC-Plus9F206-02 Fddi Repeater MicroLAN Module User’s Guide Page DOC Notice FCC NoticeClass 1 Laser Transceivers Safety InformationLaser Radiation and Connectors Contents Introduction FeaturesLanview LEDs 9F206-02 Getting Help Related ManualsUnpacking the Module Installing the MicroLAN ModuleInstalling an Fpim Installing an Fpim User-Accessible Components User-Accessible ComponentsLocation of Module DIP Switch Setting the Module Card DIP SwitchSwitch Function Description Off Factory Default Function of DIP SwitchInstalling the Module into the MMAC-Plus Chassis Installing the MicroLAN Module Reset Switch Reset SwitchFlexible Network Bus FNB OperationFNB Interface System Diagnostic ControllerSystem Management Bus DC/DC ConverterCPU F206-02 Lanview Lanview LEDsLED Color State Description SMB and CPU LEDsLED Color State Fddi Port Status LEDsFddi Status LEDs LED ColorGeneral Speciﬁcations SafetyService Physical Parameter Typical Value Worst Worst Case Budget Fpim SpeciﬁcationsFPIM-00 and FPIM-01 Table A-1. FPIM-00 and FPIM-01 SpeciﬁcationsPin Number Represents Table A-2. Transmitter Power ParametersFPIM-02 and FPIM-04 Table A-3. FPIM-04 PinoutsParameter Typical Minimum Maximum FPIM-05 and FPIM-07Table A-4. FPIM-05 and FPIM-07 Speciﬁcations