Cabletron Systems FDDI Repeater manual Table A-4. FPIM-05 and FPIM-07 Specifications

Page 29

FPIM-05 and FPIM-07

FPIM-05 and FPIM-07

The FPIM-05 and FPIM-07 provide a Single-mode fiber connection. The FPIM-05 uses a MIC style connector and the FPIM-07 uses an SC type connector. The specifications for both devices are listed in Table A-4.

Table A-4. FPIM-05 and FPIM-07 Specifications

Parameter

Typical

Minimum

Maximum

 

 

 

 

 

 

 

 

Transmitter Peak Wave

1300 nm

1270 nm

1330 nm

Length

 

 

 

 

 

 

 

Spectral Width

60 nm

-

100 nm

 

 

 

 

Rise Time

3.0 nsec

2.7 nsec

5.0 nsec

 

 

 

 

Fall Time

2.5 nsec

2.2 nsec

5.0 nsec

 

 

 

 

Duty Cycle

50.1%

49.6%

50.7%

 

 

 

 

Bit Error Rate

Better than 10-10

 

 

 

 

 

 

The link distance is up to 40 kilometers (max) and 25 kilometers (typical) on single mode fiber-optic cable as specified by ANSI SMF-PMD.

A-3

Image 29
Contents MMAC-Plus9F206-02 Fddi Repeater MicroLAN Module User’s Guide Page DOC Notice FCC NoticeClass 1 Laser Transceivers Safety InformationLaser Radiation and Connectors Contents Introduction FeaturesLanview LEDs 9F206-02 Getting Help Related ManualsUnpacking the Module Installing the MicroLAN ModuleInstalling an Fpim Installing an Fpim User-Accessible Components User-Accessible ComponentsLocation of Module DIP Switch Setting the Module Card DIP SwitchSwitch Function Description Off Factory Default Function of DIP SwitchInstalling the Module into the MMAC-Plus Chassis Installing the MicroLAN Module Reset Switch Reset SwitchFlexible Network Bus FNB OperationSystem Management Bus System Diagnostic ControllerDC/DC Converter FNB InterfaceCPU F206-02 Lanview Lanview LEDsLED Color State Description SMB and CPU LEDsFddi Status LEDs Fddi Port Status LEDsLED Color LED Color StateGeneral Specifications SafetyService Physical FPIM-00 and FPIM-01 Fpim SpecificationsTable A-1. FPIM-00 and FPIM-01 Specifications Parameter Typical Value Worst Worst Case BudgetFPIM-02 and FPIM-04 Table A-2. Transmitter Power ParametersTable A-3. FPIM-04 Pinouts Pin Number RepresentsParameter Typical Minimum Maximum FPIM-05 and FPIM-07Table A-4. FPIM-05 and FPIM-07 Specifications