Installing the MicroLAN Module
Installing the Module into the MMAC-Plus Chassis
MMAC-Plus MicroLAN Modules can be installed in any of the 14 slots that are available. To install, follow the steps below:
1.Switch off the power supplies and remove all power from the MMAC-Plus chassis.
2.Remove the blank panels, covering the slots that the module is being mounted in. All other slots must be covered, if modules are not being installed, to ensure proper airflow and cooling.
3.Attach one end of the ESD wrist strap packaged with the MMAC-Plus chassis to your wrist. Plug the other end into the ESD Wrist Strap Grounding receptacle in the lower right corner of the MMAC-Plus Chassis shown in Figure 2-4.
4.The module is installed into the chassis by sliding it into slots and locking down both the top and bottom plastic tabs, as shown in Figure 2-4.Take care that the module slides in straight and engages the backplane connectors properly. When installing the module, ensure that both circuit cards are between the card guides, as shown in Figure 2-4.Check both the upper and lower tracks of both cards.
2-6
