Cabletron Systems FDDI Repeater manual FCC Notice, DOC Notice

Page 3

Notice

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

DOC Notice

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

ii

Image 3
Contents MMAC-Plus9F206-02 Fddi Repeater MicroLAN Module User’s Guide Page DOC Notice FCC NoticeClass 1 Laser Transceivers Safety InformationLaser Radiation and Connectors Contents Introduction FeaturesLanview LEDs 9F206-02 Getting Help Related ManualsInstalling the MicroLAN Module Installing an FpimUnpacking the Module Installing an Fpim User-Accessible Components User-Accessible ComponentsLocation of Module DIP Switch Setting the Module Card DIP SwitchSwitch Function Description Off Factory Default Function of DIP SwitchInstalling the Module into the MMAC-Plus Chassis Installing the MicroLAN Module Reset Switch Reset SwitchFlexible Network Bus FNB OperationFNB Interface System Diagnostic ControllerSystem Management Bus DC/DC ConverterCPU F206-02 Lanview Lanview LEDsLED Color State Description SMB and CPU LEDsLED Color State Fddi Port Status LEDsFddi Status LEDs LED ColorSafety ServiceGeneral Specifications Physical Parameter Typical Value Worst Worst Case Budget Fpim SpecificationsFPIM-00 and FPIM-01 Table A-1. FPIM-00 and FPIM-01 SpecificationsPin Number Represents Table A-2. Transmitter Power ParametersFPIM-02 and FPIM-04 Table A-3. FPIM-04 PinoutsFPIM-05 and FPIM-07 Table A-4. FPIM-05 and FPIM-07 SpecificationsParameter Typical Minimum Maximum