Cabletron Systems FDDI Repeater manual Installing the MicroLAN Module

Page 17

Installing the Module into the MMAC-Plus Chassis

Jack for ESD wrist strap

Metal Back-Panel

Circuit Card

Card Guides

Warning:

Ensure that the circuit card is between the card guides.

Lock down the top and bottom plastic tabs at the same time, applying even pressure.

Figure 2-4. Installing the MicroLAN Module

2-7

Image 17

Contents MMAC-Plus9F206-02 Fddi Repeater MicroLAN Module User’s Guide Page DOC Notice FCC NoticeClass 1 Laser Transceivers Safety InformationLaser Radiation and Connectors Contents Introduction FeaturesLanview LEDs 9F206-02 Getting Help Related ManualsUnpacking the Module Installing the MicroLAN ModuleInstalling an Fpim Installing an Fpim User-Accessible Components User-Accessible ComponentsLocation of Module DIP Switch Setting the Module Card DIP SwitchSwitch Function Description Off Factory Default Function of DIP SwitchInstalling the Module into the MMAC-Plus Chassis Installing the MicroLAN Module Reset Switch Reset SwitchFlexible Network Bus FNB OperationSystem Management Bus System Diagnostic ControllerDC/DC Converter FNB InterfaceCPU F206-02 Lanview Lanview LEDsLED Color State Description SMB and CPU LEDsFddi Status LEDs Fddi Port Status LEDsLED Color LED Color StateGeneral Speciﬁcations SafetyService Physical FPIM-00 and FPIM-01 Fpim SpeciﬁcationsTable A-1. FPIM-00 and FPIM-01 Speciﬁcations Parameter Typical Value Worst Worst Case BudgetFPIM-02 and FPIM-04 Table A-2. Transmitter Power ParametersTable A-3. FPIM-04 Pinouts Pin Number RepresentsParameter Typical Minimum Maximum FPIM-05 and FPIM-07Table A-4. FPIM-05 and FPIM-07 Speciﬁcations