Cabletron Systems FDDI Repeater manual Reset Switch

Page 18

Installing the MicroLAN Module

The Reset Switch

The Reset switch is located on the front panel, under the top plastic tab as shown in Figure 2-5.It serves two functions:

•Pressing the Reset switch twice within three seconds causes the main CPU to reset.

•Pressing and holding the switch on for three or more seconds causes the module to shutdown. Pressing and holding again for three seconds restarts the module.

Reset Switch

Figure 2-5. The Reset Switch

2-8

Image 18

Contents

MMAC-Plus9F206-02 Fddi Repeater MicroLAN Module User’s Guide Page FCC Notice DOC NoticeSafety Information Class 1 Laser TransceiversLaser Radiation and Connectors Contents Features IntroductionLanview LEDs 9F206-02 Related Manuals Getting HelpInstalling the MicroLAN Module Installing an FpimUnpacking the Module Installing an Fpim User-Accessible Components User-Accessible Components Setting the Module Card DIP Switch Location of Module DIP SwitchFunction of DIP Switch Switch Function Description Off Factory DefaultInstalling the Module into the MMAC-Plus Chassis Installing the MicroLAN Module Reset Switch Reset SwitchOperation Flexible Network Bus FNBDC/DC Converter System Diagnostic ControllerSystem Management Bus FNB InterfaceCPU Lanview LEDs F206-02 LanviewSMB and CPU LEDs LED Color State DescriptionLED Color Fddi Port Status LEDsFddi Status LEDs LED Color StateSafety ServiceGeneral Speciﬁcations Physical Table A-1. FPIM-00 and FPIM-01 Speciﬁcations Fpim SpeciﬁcationsFPIM-00 and FPIM-01 Parameter Typical Value Worst Worst Case BudgetTable A-3. FPIM-04 Pinouts Table A-2. Transmitter Power ParametersFPIM-02 and FPIM-04 Pin Number RepresentsFPIM-05 and FPIM-07 Table A-4. FPIM-05 and FPIM-07 SpeciﬁcationsParameter Typical Minimum Maximum