Cabletron Systems FDDI Repeater manual SMB and CPU LEDs, LED Color State Description

Page 23

LANVIEW LEDs

The functions of the System Management Bus (SMB) and CPU LEDs are listed in Table 4-1.

Table 4-1. SMB and CPU LEDs

LED Color

State

Description

 

 

 

 

 

 

Green

Functional

Fully operational.

 

 

 

Yellow (Flashing)

Crippled

Not fully operational (i.e., one bad port).

 

 

 

Yellow/Green

Booting

Blinks yellow and green while booting.

 

 

 

Red

Reset

Normal power-up reset.

 

 

 

Red (Flashing)

Failed

Fatal error has occurred.

 

 

 

Off

Power off

Module powered off.

 

 

 

There is one row of FDDI Port Status LEDs for each FDDI ring, FNB-1 and FNB-2. The functions of the FDDI LEDs are shown in Figure 4-2and Table 4-2.

FDDI-1

Port B Status

FDDI-1 Status (Inserted/Bypassed)

FDDI-1

Port A Status

FDDI-2

Port B Status

FDDI-2 Status (Inserted/Bypassed)

FDDI-2

Port A Status

Figure 4-2. FDDI LEDs

4-2

Image 23
Contents MMAC-Plus9F206-02 Fddi Repeater MicroLAN Module User’s Guide Page DOC Notice FCC NoticeClass 1 Laser Transceivers Safety InformationLaser Radiation and Connectors Contents Introduction FeaturesLanview LEDs 9F206-02 Getting Help Related ManualsUnpacking the Module Installing the MicroLAN ModuleInstalling an Fpim Installing an Fpim User-Accessible Components User-Accessible ComponentsLocation of Module DIP Switch Setting the Module Card DIP SwitchSwitch Function Description Off Factory Default Function of DIP SwitchInstalling the Module into the MMAC-Plus Chassis Installing the MicroLAN Module Reset Switch Reset SwitchFlexible Network Bus FNB OperationFNB Interface System Diagnostic ControllerSystem Management Bus DC/DC ConverterCPU F206-02 Lanview Lanview LEDsLED Color State Description SMB and CPU LEDsLED Color State Fddi Port Status LEDsFddi Status LEDs LED ColorGeneral Specifications SafetyService Physical Parameter Typical Value Worst Worst Case Budget Fpim SpecificationsFPIM-00 and FPIM-01 Table A-1. FPIM-00 and FPIM-01 SpecificationsPin Number Represents Table A-2. Transmitter Power ParametersFPIM-02 and FPIM-04 Table A-3. FPIM-04 PinoutsParameter Typical Minimum Maximum FPIM-05 and FPIM-07Table A-4. FPIM-05 and FPIM-07 Specifications