USING COMMUNITY NAMES
Community Names Table
Four fields, Community Name, Access, Traps, and IP Address, can be configured on the Community Names screen. Up to eight community name entries can be used to define SNMP compliant network management workstations that are allowed access to the MRXI and designate workstations that will receive alarms from the MRXI.
Community Name - is a name, up to 32 characters in length, that you can enter to designate specific SNMP Compliant Community Names that are permitted to access and receive alarms from the MRXI. Highlight the desired Community Names field and enter the community name information directly into the name field.
Access - defines the type of access permitted from a network management workstation configured with the associated community name. Highlight this field and press Return to toggle between the following possible entries:
RO | Read Only |
RW | Read and Write Access |
NA | Not Accessible |
SU | Super User access defines names that are used as local |
| passwords and is required to enter information in the |
| Community Names Table. |
Traps - enables or disables SNMP trap messages to the network management station with the associated IP Address. Highlight this field, and press Return to toggle this field between YES and NO. YES enables traps. NO disables traps.
IP Address - is the IP Address of the network management workstation that will receive SNMP trap messages when enabled (yes) by the Traps field. Highlight this field and enter the IP address of the workstation directly into the IP Address field. The format for this entry is 4 decimal values between 1 and 254 with a period as a separator between the values as follows:
254.254.254.254
Page