Cabletron Systems TRFMIM-28 manual FCC Notice, VCCI Notice, DOC Notice

Page 4
FCC Notice

Notice

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

VCCI Notice

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

DOC Notice

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

ii

Image 4
Contents SmartSwitch 9H423-28 User’s Guide 9032061-01Page Copyright March 1998 by Cabletron Systems, Inc 35 Industrial Way VCCI Notice FCC NoticeDOC Notice Nexus House, Newbury Business Park DECLARATION OF CONFORMITY ADDENDUMConformance to Directives/Product Standards CLASS 1 LASER TRANSCEIVERS Safety InformationThe FPIM-05 and FPIM-07 are Class 1 Laser Products CLASS 1 LASER TRANSCEIVERS Laser Radiation and Connectors Page Contents Installing the 9H423-28 ModuleChapter IntroductionContents Specificationsviii Introduction ChapterFeatures Fast Packet SwitchingProcessor ManagementThe 9H423-28 module provides MIB support including RMON RFC-1271 LANVIEW LEDs Figure 1-1. The 9H423-28 Module 26X 25XFAST ENET 9H423-28 SMB CPU INB FAST ENETRelated Manuals Getting HelpInstalling an FEPIM Installing the 9H423-28 ModuleUnpacking the Module User Accessible Components Setting the Module DIP Switch Table 2-1. Function of DIP Switch See the Cautions at the end of this tableInstalling the Module in the SmartSwitch 9000 Chassis Figure 2-3. Installing the Module Plastic Tab Jack for ESD Wrist StrapMetal Back-Panel ModuleThe Reset Switch Reset SwitchInstalling the 9H423-28 Module Operation ENIB/FENIB OperationTraditional Switch SmartSwitch ASICVLAN VLAN Domains SecureFast VLAN Switches Fully-Meshed VLAN Domainsi960 Core INB NIBSystem Management Buses SMB-1 BusSystem Diagnostic Controller DC/DC ConverterINB Interface SMB-10 BusITDM Arbitration Levels ITDM RAM Allocation LevelRound Robin Arbitration Level Lowest Slot Number LevelMonarch/Slave SmartSwitch 9000 Modules 3-10 LANVIEW LEDs INB ReceivePort Transmit System Status INB Transmit Port ReceiveThe function of the INB Transmit LEDs is listed in Table The function of the INB Receive LEDs is listed in TableLANVIEW LEDs The function of the Port Receive LEDs is listed in Table The function of the Port Transmit LEDs is listed in TableTable 4-4. Port Receive LEDs Table 4-5. Port Transmit LEDsLANVIEW LEDs Specifications Technical SpecificationsMemory StandardsSafety ServiceDimensions WeightEnvironment Operating Temperature5 to 40 C Storage TemperatureSpecifications FEPIM Specifications FE-100TXFE-100FX Appendix AFE-100FX FEPIM Specifications