Cabletron Systems FDDI INSTALLING/REMOVING the 7F06-02 Module, Installing in the 7C03 SmartSwitch

Page 21

Chapter 3: Installation/Removal

3.3INSTALLING/REMOVING THE 7F06-02 MODULE

The following procedure details the installation and removal procedure for the 7F06-02 module.

3.3.1Installing in the 7C03 SmartSwitch

The 7F06-02 Module is installed in the 7C03 MMAC SmartSwitch using the following steps and referring to Figure 3-2.

Note: The left-most slot in the 7C03 MMAC SmartSwitch is reserved for the 7X00 SmartSwitch Module.

Note: Before installing the 7F06-02 module, attach the antistatic wrist strap included with the SmartSwitch or SmartSwitch module by following the instructions printed on the package.

1.As a precaution, power down the MMAC 8 before beginning the installation or removal of any modules. At the very minimum, the 7C03 must be pulled to disconnect it from the power source. Damage to modules may result if this procedure is not followed.

2.Remove the blank panel covering the slot in which the module will be installed. All other slots must remain covered to ensure proper airflow and cooling.

3.Install the module by sliding it into slots as shown in Figure 3-2. Ensure that the printed circuit board (PCB) is between the card guides, slides in straight, and engages the backplane connectors properly.

4.Using a slotted screwdriver, tighten the top and bottom screws.

Card

Guides

Figure 3-2 Installing the 7F06-02 Module in the

7C03 MMAC SmartSwitch

7F06-02 FDDI SmartSwitch Interface Module User’s Guide

3-3

Page 20 Page 22
Image 21
Page 20 Page 22
Contents 7F06-02 Fddi SmartSwitch Interface Module User’s Guide Page FCC Notice 7F06-02 Fddi SmartSwitch Interface Module User’s GuideDOC Notice Vcci NoticeCabletron SYSTEMS, INC. Program License Agreement Exclusion of Warranty and Disclaimer of Liability Cabletron Software Program LicenseUnited States Government Restricted Rights PO Box Rochester, NH Declaration of ConformityContents Contents Using this Manual Chapter Introduction7F06-02 Module 7F06-02 Module Cable Type and FPIMsFeatures FPIMsLanview LEDs Related Manuals ConnectivityGetting Help Service and Support7F06-02 Fddi SmartSwitch Interface Module User’s Guide Fpim Module Specifications Chapter Network RequirementsFPIM-00 and FPIM-01 FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05 and FPIM-077F06-02 Fddi SmartSwitch Interface Module User’s Guide Unpacking the 7F06-02 Module Chapter INSTALLATION/REMOVALInstalling an Fpim Installing FpimsInstalling in the 7C03 SmartSwitch INSTALLING/REMOVING the 7F06-02 ModuleRemoving the 7F06-02 Module from the 7C03 Mmac SmartSwitch Removing from the 7C03 SmartSwitchInstalling in the 7C04 or 7C04-R Workgroup SmartSwitch Screw Screws Ejector Tabs Installation/Removal Diagnostic and Monitoring System Chapter TroubleshootingPort Receive Leds Port Transmit LedsA/B Link Leds Twisted A-A, B-B 7F06-02 Fddi SmartSwitch Interface Module User’s Guide Standards Chapter Technical SpecificationsEMI EMCService SafetyDimensions Weight
Top Page Image Contents