Cabletron Systems FDDI manual Installing in the 7C04 or 7C04-R Workgroup SmartSwitch

Page 23

Chapter 3: Installation/Removal

3.3.3Installing in the 7C04 or 7C04-R Workgroup SmartSwitch

The 7F06-02 Module is installed in the 7C04 or 7C04-R Workgroup SmartSwitch using the following steps and referring to Figures 3-4 and 3-5.

Notes: The top slot in the 7C04 Workgroup SmartSwitch is reserved for the 7X00 SmartSwitch Module.

The bottom slot in the 7C04-R Workgroup SmartSwitch is reserved for the 7X00 SmartSwitch Module.

Therefore, before installing the 7F06-02 module, attach the wrist strap included with the SmartSwitch or SmartSwitch module by following the instructions printed on the package.

1.As a precaution, power down the MMAC 8 before beginning the installation or removal of any modules. At the very minimum, the 7C04 or 7C04-R must be pulled to disconnect it from the power source. Damage to modules may result if this procedure is not followed.

2.Remove the blank panel covering the slot in which the module will be installed. All other slots must remain covered to ensure proper airflow and cooling.

3.Install the module by sliding it into slots as shown in the appropriate figure. Ensure that the printed circuit board (PCB) is between the card guides, slides in straight, and engages the backplane connectors properly.

4.Using a slotted screwdriver, tighten the top and bottom screws.

7F06-02 FDDI SmartSwitch Interface Module User’s Guide

3-5

Page 22 Page 24
Image 23
Page 22 Page 24
Contents 7F06-02 Fddi SmartSwitch Interface Module User’s Guide Page FCC Notice 7F06-02 Fddi SmartSwitch Interface Module User’s GuideCabletron SYSTEMS, INC. Program License Agreement DOC NoticeVcci Notice United States Government Restricted Rights Exclusion of Warranty and Disclaimer of LiabilityCabletron Software Program License PO Box Rochester, NH Declaration of ConformityContents Contents 7F06-02 Module Using this ManualChapter Introduction 7F06-02 Module Cable Type and FPIMsLanview LEDs FeaturesFPIMs Related Manuals ConnectivityGetting Help Service and Support7F06-02 Fddi SmartSwitch Interface Module User’s Guide FPIM-00 and FPIM-01 Fpim Module SpecificationsChapter Network Requirements FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05 and FPIM-077F06-02 Fddi SmartSwitch Interface Module User’s Guide Unpacking the 7F06-02 Module Chapter INSTALLATION/REMOVALInstalling an Fpim Installing FpimsInstalling in the 7C03 SmartSwitch INSTALLING/REMOVING the 7F06-02 ModuleRemoving the 7F06-02 Module from the 7C03 Mmac SmartSwitch Removing from the 7C03 SmartSwitchInstalling in the 7C04 or 7C04-R Workgroup SmartSwitch Screw Screws Ejector Tabs Installation/Removal Diagnostic and Monitoring System Chapter TroubleshootingA/B Link Leds Port Receive LedsPort Transmit Leds Twisted A-A, B-B 7F06-02 Fddi SmartSwitch Interface Module User’s Guide EMC Chapter Technical SpecificationsStandards EMIWeight SafetyService Dimensions
Top Page Image Contents