Cabletron Systems FDDI manual Removing from the 7C03 SmartSwitch

Chapter 3: Installation/Removal

3.3.2Removing from the 7C03 SmartSwitch

The 7F06-02 Module inserted in the 7C03 MMAC SmartSwitch can be removed upon proper removal of power. Follow the steps below and refer to Figure 3-3 to remove the module.

Note: Before removing the 7F06-02 module, attach the antistatic wrist strap included with the SmartSwitch or SmartSwitch module by following the instructions printed on the package.

1.As a precaution, power down the MMAC 8 before beginning the installation or removal of any modules. At the very minimum, the 7C03 must be pulled to disconnect it from the power source. Damage to modules may result if this procedure is not followed.

2.Use a slotted screwdriver to loosen the two screws that secure the module to the chassis.

3.Locate the two ejector tabs on the module (to the right of the screws on the top and bottom of the module).

4.Simultaneously press down on the bottom ejector tab and up on the top ejector tab until the module ejects from the backplane.

5.Grasp both ejector tabs and carefully slide the module out of the chassis.

Screw

Ejector Tab

Screw

Ejector Tab

Figure 3-3 Removing the 7F06-02 Module from the 7C03 MMAC

SmartSwitch

3-4 7F06-02 FDDI SmartSwitch Interface Module User’s Guide