Cabletron Systems FDDI manual Screws Ejector Tabs

Page 25

Chapter 3: Installation/Removal

3.3.4Removing the 7F06-02 from the 7C04 or 7C04-R Workgroup SmartSwitch

The 7F06-02 Module, inserted in the 7C04 or the 7C04-R

Workgroup SmartSwitch, can be removed whenever necessary. Follow the steps below and refer to Figures 3-6 or 3-7 to remove the module.

Note: Before removing the 7F06-02 module, attach the antistatic wrist strap included with the SmartSwitch or SmartSwitch module by following the instructions printed on the package.

1.As a precaution, power down the MMAC 8 before beginning the installation or removal of any modules. At the very minimum the 7C04 or 7C04-R must be pulled to disconnect it from the power source. Damage to modules may result if this procedure is not followed.

2.Use a slotted screwdriver to loosen the two screws that secure the module to the chassis.

3.Locate the two ejector tabs on the module (below the screws on the left and right end of the module).

4.Simultaneously press left on the left ejector tab and right on the right ejector tab until the module ejects from the backplane.

5.Grasp both ejector tabs and carefully slide the module out of the chassis.

Screws

1

2

3

4

Ejector Tabs

Figure 3-6 Removing the 7F06-02 Module from the 7C04 Workgroup

SmartSwitch

7F06-02 FDDI SmartSwitch Interface Module User’s Guide

3-7

Page 24 Page 26
Image 25
Page 24 Page 26
Contents 7F06-02 Fddi SmartSwitch Interface Module User’s Guide Page FCC Notice 7F06-02 Fddi SmartSwitch Interface Module User’s GuideVcci Notice DOC NoticeCabletron SYSTEMS, INC. Program License Agreement Cabletron Software Program License Exclusion of Warranty and Disclaimer of LiabilityUnited States Government Restricted Rights PO Box Rochester, NH Declaration of ConformityContents Contents Chapter Introduction Using this Manual7F06-02 Module 7F06-02 Module Cable Type and FPIMsFPIMs FeaturesLanview LEDs Related Manuals ConnectivityGetting Help Service and Support7F06-02 Fddi SmartSwitch Interface Module User’s Guide Chapter Network Requirements Fpim Module SpecificationsFPIM-00 and FPIM-01 FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05 and FPIM-077F06-02 Fddi SmartSwitch Interface Module User’s Guide Unpacking the 7F06-02 Module Chapter INSTALLATION/REMOVALInstalling an Fpim Installing FpimsInstalling in the 7C03 SmartSwitch INSTALLING/REMOVING the 7F06-02 ModuleRemoving the 7F06-02 Module from the 7C03 Mmac SmartSwitch Removing from the 7C03 SmartSwitchInstalling in the 7C04 or 7C04-R Workgroup SmartSwitch Screw Screws Ejector Tabs Installation/Removal Diagnostic and Monitoring System Chapter TroubleshootingPort Transmit Leds Port Receive LedsA/B Link Leds Twisted A-A, B-B 7F06-02 Fddi SmartSwitch Interface Module User’s Guide Standards Chapter Technical SpecificationsEMI EMCService SafetyDimensions Weight
Top Page Image Contents