Interface Configuration View
Interface Configuration View
This view provides information on the configuration and operating status of the interface.
To access the Interface Configuration view do the following:
1.Within the Interface Device view, highlight the device icon.
2.From the Icon Subviews menu, select IF Configuration.
The Interface Configuration view provides the following information:
Operation Status
Displays the status of the module. Possible values are operational, notoperational and unknown.
Admin. Status
Provides a menu button to set the Administrative status of the port. Once disabled, a port must be explicitly enabled to restore operation. A port that is already disabled when power is lost or when a reset is exerted will remain disabled when normal operation resumes. Possible values are On, Off, and Testing.
Last Change
Displays the system uptime at which the interface entered its current operational state. A value of zero indicates that the status has not changed since the agent was last restarted.
Network Name/Address
Displays the network name and the address at which it appears.
Physical Address
Displays the physical (MAC) address of the interface or port.
Bandwidth
Displays the interface bandwidth in bits per second. For interfaces that do not vary in bandwidth or for which no accurate estimate can be made, this will be the nominal bandwidth.
Packet Size
Displays the largest Maximum Transmission Unit (MTU) that can be transmitted or recieved by the port, measured in octets.
Queue Length
Displays the length of the outbound packet queue in packets.
Configuration Views | 3Com PortSwitch Hubs |
Management Module Guide |