Cabletron Systems BRIM-A6 manual Installing Apims, Installing an Apim

Page 15

Chapter 2: Installation

2.2 INSTALLING APIMS

To install an APIM into the BRIM-A6:

1.Attach the disposable grounding strap to your wrist (refer to the instructions on the disposable grounding strap package).

2.Remove the two faceplate screws from the BRIM. See Figure 2-1.

3.Remove the three screws from the BRIM standoffs. See Figure 2-1.

4.Insert the APIM connector into the BRIM connector. See Figure 2-1.

APIM SCREWS

STS

LNK APIM

APIM CONNECTOR

STANDOFF

BRIM-
A6
STS	PWR
	PWR
XMT	RCV
	RCV

FACEPLATE SCREWS

BRIM CONNECTOR

131101

Figure 2-1 Installing an APIM

5.Press down firmly on the APIM until the APIM connector slides all the way into the BRIM connector. Ensure the APIM sits flush on the standoffs.

6.Secure the APIM with the screws provided with the APIM.

7.Reattach the faceplate to the BRIM.

Page 2-2

BRIM-A6 User’s Guide

Image 15

Contents BRIM-A6 USER’S Guide BRIM-A6 User’s Guide FCC Notice DOC NoticeVcci Notice Exclusion of Warranty and Disclaimer of Liability Cabletron SYSTEMS, INC. Program License AgreementCabletron Software Program License United States Government Restricted Rights Declaration of Conformity Contents Viii BRIM-A6 User’s Guide Chapter Introduction Using this ManualFollowing conventions are used throughout this document Document ConventionsBRIM-A6 Overview BRIM-A6 FeaturesEMC BRIM-A6 SpecificationsRelated Manuals EMIGetting Help Unpacking the Brim Chapter InstallationInstalling an Apim Installing ApimsInstalling a Brim in a MIM Installing BrimsRemoving the Brim Coverplate Installing a Brim in a Hub BRIM-A6 User’s Guide Chapter Local Management Keyboard Conventions Function Local Management Keyboard ConventionsATM Connection Tables Screen Using LIM to Create PVCsATM Connection Tables Screen Fields Using ATM Connection Tables Screen Commands ATM Connection Tables Screen CommandsDeleting PVCs from the Connection Tables Screen Adding PVCs to the Connection Tables ScreenBRIM-A6 Setup Screen Using LM to Create PvcsBRIM-A6 Setup Screen Fields VPIVCI BRIM-A6 Setup Screen Commands Accessing the BRIM-A6 Add/Delete Entry Screen Using BRIM-A6 Setup Screen CommandsBRIM-A6 Add/Delete Entry Screen Fields Adding a PVC BRIM-A6 Add/Delete Entry Screen CommandsModifying a PVC Deleting a PVC BRIM-A6 LEDs ChapterDescribes each of the Apim LEDs Apim LEDsAppendix a Apim Specifications APIM-11 SpecificationsAPIM-21 Specifications APIM-29 Specifications APIM-22 SpecificationsBNC APIM-67 SpecificationsATM Basics Appendix B ATM OverviewFigure B-1 ATM Cells ATM CellBRIM-A6 User’s Guide B-3 Virtual Channels and Virtual Paths ATM NetworkATM Protocol Permanent and Switched Virtual ChannelsB-6 BRIM-A6 User’s Guide BRIM-A6 User’s Guide B-7 B-8 BRIM-A6 User’s Guide