Cabletron Systems BRIM-A6 manual Installing a Brim in a Hub

Page 18

Installing BRIMs

8.Place the BRIM behind the MIM faceplate. See Figure 2-3.

9.Insert the connector pins of the BRIM-A6 into the BRIM connector on the MIM.

10.Press down firmly on the back of the BRIM until the pins slide all the way into the connector holes.

NOTE

Ensure that the standoffs on the MIM align with the standoff screw holes on the BRIM.

11.Reinstall the mounting screws and the standoff screws.

12.Reinstall the MIM in the MMAC.

13.Reattach all MMAC power cords.

14.Reattach the network cabling to the MIM.

15.Refer to Chapter 3 for instructions on configuring the BRIM-A6 using Local Management.

2.3.2 Installing a BRIM in a Hub

To install a BRIM-A6 into a standalone hub that supports BRIM technology:

1.Power down the hub and remove the power cord.

2.Disconnect all cables from the hub. Note the ports to which these cables attach.

Ensure that you remove the power cord and ONLY the screws required to remove the chassis cover. Failure to comply could result in an electric shock hazard.

3.Attach the disposable grounding strap to your wrist (refer to the instructions outlined on the disposable grounding strap package).

4.Remove the hub chassis cover (refer to your specific hub documentation for instructions on removing the hub chassis cover).

BRIM-A6 User’s Guide

Page 2-5

Image 18
Contents BRIM-A6 USER’S Guide BRIM-A6 User’s Guide FCC Notice DOC NoticeVcci Notice Exclusion of Warranty and Disclaimer of Liability Cabletron SYSTEMS, INC. Program License AgreementCabletron Software Program License United States Government Restricted Rights Declaration of Conformity Contents Viii BRIM-A6 User’s Guide Using this Manual Chapter IntroductionDocument Conventions Following conventions are used throughout this documentBRIM-A6 Features BRIM-A6 OverviewEMI BRIM-A6 SpecificationsRelated Manuals EMCGetting Help Chapter Installation Unpacking the BrimInstalling Apims Installing an ApimInstalling Brims Installing a Brim in a MIMRemoving the Brim Coverplate Installing a Brim in a Hub BRIM-A6 User’s Guide Chapter Local Management Local Management Keyboard Conventions Keyboard Conventions FunctionUsing LIM to Create PVCs ATM Connection Tables ScreenATM Connection Tables Screen Fields ATM Connection Tables Screen Commands Using ATM Connection Tables Screen CommandsAdding PVCs to the Connection Tables Screen Deleting PVCs from the Connection Tables ScreenUsing LM to Create Pvcs BRIM-A6 Setup ScreenBRIM-A6 Setup Screen Fields VPIVCI BRIM-A6 Setup Screen Commands Using BRIM-A6 Setup Screen Commands Accessing the BRIM-A6 Add/Delete Entry ScreenBRIM-A6 Add/Delete Entry Screen Fields BRIM-A6 Add/Delete Entry Screen Commands Adding a PVCModifying a PVC Deleting a PVC Chapter BRIM-A6 LEDsApim LEDs Describes each of the Apim LEDsAppendix a Apim Specifications APIM-11 SpecificationsAPIM-21 Specifications APIM-22 Specifications APIM-29 SpecificationsAPIM-67 Specifications BNCAppendix B ATM Overview ATM BasicsATM Cell Figure B-1 ATM CellsBRIM-A6 User’s Guide B-3 ATM Network Virtual Channels and Virtual PathsPermanent and Switched Virtual Channels ATM ProtocolB-6 BRIM-A6 User’s Guide BRIM-A6 User’s Guide B-7 B-8 BRIM-A6 User’s Guide