Cabletron Systems manual BRIM-A6 User’s Guide

Page 19

Chapter 2: Installation

5.Remove the faceplate mounting screws and the BRIM coverplate. See Figure 2-2.

6.Remove the standoff screws. See Figure 2-2.

7.Place the BRIM behind the hub faceplate. See Figure 2-3.

8.Insert the connector pins of the BRIM-A6 into the BRIM connector on the hub.

9.Press down firmly on the back of the BRIM-A6 until the pins slide all the way into the connector holes.

NOTE

Ensure that the standoffs on the hub align with the standoff screw holes on the BRIM.

10. Reinstall the faceplate mounting screws and the standoff screws.

Ensure that the chassis cover is in place before reconnecting the power cord.

11.Reattach the chassis cover to the hub, reconnect the power cord, and reconnect the hub to your network.

12.Refer to Chapter 3 for instructions on configuring the BRIM-A6 using Local Management.

Page 2-6

BRIM-A6 User’s Guide

Image 19

Contents BRIM-A6 USER’S Guide BRIM-A6 User’s Guide DOC Notice FCC NoticeVcci Notice Cabletron SYSTEMS, INC. Program License Agreement Exclusion of Warranty and Disclaimer of LiabilityCabletron Software Program License United States Government Restricted Rights Declaration of Conformity Contents Viii BRIM-A6 User’s Guide Chapter Introduction Using this ManualFollowing conventions are used throughout this document Document ConventionsBRIM-A6 Overview BRIM-A6 FeaturesEMC BRIM-A6 SpecificationsRelated Manuals EMIGetting Help Unpacking the Brim Chapter InstallationInstalling an Apim Installing ApimsInstalling a Brim in a MIM Installing BrimsRemoving the Brim Coverplate Installing a Brim in a Hub BRIM-A6 User’s Guide Chapter Local Management Keyboard Conventions Function Local Management Keyboard ConventionsATM Connection Tables Screen Using LIM to Create PVCsATM Connection Tables Screen Fields Using ATM Connection Tables Screen Commands ATM Connection Tables Screen CommandsDeleting PVCs from the Connection Tables Screen Adding PVCs to the Connection Tables ScreenBRIM-A6 Setup Screen Using LM to Create PvcsVPI BRIM-A6 Setup Screen FieldsVCI BRIM-A6 Setup Screen Commands Accessing the BRIM-A6 Add/Delete Entry Screen Using BRIM-A6 Setup Screen CommandsBRIM-A6 Add/Delete Entry Screen Fields Adding a PVC BRIM-A6 Add/Delete Entry Screen CommandsModifying a PVC Deleting a PVC BRIM-A6 LEDs ChapterDescribes each of the Apim LEDs Apim LEDsAPIM-11 Specifications Appendix a Apim SpecificationsAPIM-21 Specifications APIM-29 Specifications APIM-22 SpecificationsBNC APIM-67 SpecificationsATM Basics Appendix B ATM OverviewFigure B-1 ATM Cells ATM CellBRIM-A6 User’s Guide B-3 Virtual Channels and Virtual Paths ATM NetworkATM Protocol Permanent and Switched Virtual ChannelsB-6 BRIM-A6 User’s Guide BRIM-A6 User’s Guide B-7 B-8 BRIM-A6 User’s Guide