Cabletron Systems manual Installing the 7H02-06 Module 7C03 Mmac SmartSwitch

Page 22

Installation

1.Remove the blank panel covering the slot in which the module will be installed. All other slots in the 7C03 must remain covered to ensure proper airﬂow and cooling.

2.Slide the module into the slot. Make sure the printed circuit board (PCB) is between the card guides, slides in straight, and engages the backplane connectors properly.

3.Use a slotted screwdriver to tighten the module’s front panel screws.

	TPRMIM-20	TPRMIM-20
MAC	SP
		SN

Figure 3-3. Installing the 7H02-06 Module in the

7C03 MMAC SmartSwitch

3-4

Image 22

Contents 9031924 Page Page FCC Notice Vcci Notice Exclusion of Warranty Disclaimer of Liability Contents Appendix a Using this Manual Chapter Introduction7H02-06 Module Cable Type and FEPIMsH02-06 Module Features Lanview LEDsFE-100TX FEPIMsConnectivity Related Manuals Getting HelpChapter Network Requirements Fepim Module SpecificationsFE-100FX Transmitter power parameters are listed in Table FE-100TX and Fixed RJ45 PortsPin Number Represents Network Requirements Installing Fepims Chapter Installation Unpacking the 7H02-06 Module Ejector Tab Screws INSTALLING/REMOVING the 7H02-06 Module Installing the 7H02-06 Module in a 7C03 Mmac SmartSwitchInstalling the 7H02-06 Module 7C03 Mmac SmartSwitch Removing the 7H02-06 Module from a 7C03 Mmac SmartSwitch Removing the 7H02-06 Module from a 7C03 Mmac SmartSwitchInstalling the 7H02-06 Module in a 7C04 or 7C04-R Chassis Power Removing the 7H02-06 Module from a 7C04 or 7C04-R Chassis XXX Installation Chapter Troubleshooting Shows the Lanview LEDs of the 7H02-06 ModuleIndicates the state of the receive port System Resources Chapter Technical SpecificationsSafety StandardsNetwork Interfaces ServiceImmunity PhysicalEnvironmental Technical Speciﬁcations Figure A-1.FE-100TX Pinouts Cable Type Worst Case Budget Typical Budget