Cabletron Systems 7H02-06 manual

Page 3

Notice

NOTICE

Cabletron Systems reserves the right to make changes in speciﬁcations and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, ﬁrmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

© Copyright July 22, 1996 by:

Cabletron Systems, Inc.,

35 Industrial Way

Rochester, NH 03867-0505

All Rights Reserved

Printed in the United States of America

Order Number: 9031924 July 22, 1996

LANVIEW® is a registered trademark of Cabletron Systems, Inc.

Ethernet is a trademark of Xerox Corp.

CompuServe® is a registered trademark of CompuServe, Inc.

i

Image 3

Contents 9031924 Page Page FCC Notice Vcci Notice Exclusion of Warranty Disclaimer of Liability Contents Appendix a Chapter Introduction Using this ManualCable Type and FEPIMs 7H02-06 ModuleH02-06 Module Lanview LEDs FeaturesFEPIMs FE-100TXConnectivity Getting Help Related ManualsFepim Module Specifications Chapter Network RequirementsFE-100FX FE-100TX and Fixed RJ45 Ports Transmitter power parameters are listed in TablePin Number Represents Network Requirements Chapter Installation Installing FepimsUnpacking the 7H02-06 Module Ejector Tab Screws Installing the 7H02-06 Module in a 7C03 Mmac SmartSwitch INSTALLING/REMOVING the 7H02-06 ModuleInstalling the 7H02-06 Module 7C03 Mmac SmartSwitch Removing the 7H02-06 Module from a 7C03 Mmac SmartSwitch Removing the 7H02-06 Module from a 7C03 Mmac SmartSwitchInstalling the 7H02-06 Module in a 7C04 or 7C04-R Chassis Power Removing the 7H02-06 Module from a 7C04 or 7C04-R Chassis XXX Installation Shows the Lanview LEDs of the 7H02-06 Module Chapter TroubleshootingIndicates the state of the receive port Standards Chapter Technical SpecificationsSafety System ResourcesPhysical ServiceImmunity Network InterfacesEnvironmental Technical Speciﬁcations Figure A-1.FE-100TX Pinouts Cable Type Worst Case Budget Typical Budget