Cabletron Systems 7H02-06 manual Exclusion of Warranty Disclaimer of Liability

Page 6

Notice

EXCLUSION OF WARRANTY

AND DISCLAIMER OF LIABILITY

1.EXCLUSION OF WARRANTY. Except as may be specifically provided by Cabletron in writing, Cabletron makes no warranty, expressed or implied, concerning the Program (including Its documentation and media).

CABLETRON DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY CABLETRON IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABLITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN MATERIALS, AND ANY ACCOMPANYING HARDWARE.

2.NO LIABILITY FOR CONSEQUENTIAL DAMAGES. IN NO EVENT SHALL CABLETRON OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS, PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR RELIANCE DAMAGES, OR OTHER LOSS) ARISING OUT OF THE USE OR INABILITY TO USE THIS CABLETRON PRODUCT, EVEN IF CABLETRON HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, OR ON THE DURATION OR LIMITATION OF IMPLIED WARRANTEES IN SOME INSTANCES THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU.

iv

Image 6
Contents 9031924 Page Page FCC Notice Vcci Notice Exclusion of Warranty Disclaimer of Liability Contents Appendix a Using this Manual Chapter Introduction7H02-06 Module Cable Type and FEPIMsH02-06 Module Features Lanview LEDsFEPIMs FE-100TXConnectivity Related Manuals Getting HelpFepim Module Specifications Chapter Network RequirementsFE-100FX Transmitter power parameters are listed in Table FE-100TX and Fixed RJ45 PortsPin Number Represents Network Requirements Chapter Installation Installing FepimsUnpacking the 7H02-06 Module Ejector Tab Screws INSTALLING/REMOVING the 7H02-06 Module Installing the 7H02-06 Module in a 7C03 Mmac SmartSwitchInstalling the 7H02-06 Module 7C03 Mmac SmartSwitch Removing the 7H02-06 Module from a 7C03 Mmac SmartSwitch Removing the 7H02-06 Module from a 7C03 Mmac SmartSwitchInstalling the 7H02-06 Module in a 7C04 or 7C04-R Chassis Power Removing the 7H02-06 Module from a 7C04 or 7C04-R Chassis XXX Installation Chapter Troubleshooting Shows the Lanview LEDs of the 7H02-06 ModuleIndicates the state of the receive port System Resources Chapter Technical SpecificationsSafety StandardsNetwork Interfaces ServiceImmunity PhysicalEnvironmental Technical Specifications Figure A-1.FE-100TX Pinouts Cable Type Worst Case Budget Typical Budget