2.Noting the color that is shifted furthest left, press the select button accordingly to select that color (see table above). The corresponding LED lights.
3.Viewing the image, slowly rotate the Adjust knob until the selected color converges with the color furthest right.
4.Repeat steps 2 and 3 for the remaining color until all three colors are converged.
For Level Adjustment.
1.Press the select button four times to enter the level function. The green LED blinks.
2.View the image critically and rotate the adjust knob to increase or decrease the brightness of the displayed image.
For Peaking Adjustment.
1.Press the select button five times to enter the level function. The blue LED blinks.
2.View the image critically and rotate the adjust knob to increase or decrease the sharpness of the displayed image.
Resetting Skew Delay, Level and Peaking
To reset the skew delay, level, and peaking, press and hold the select button for three seconds. Release the select button.
Operation
After the transmitter, all receivers, and their connected devices are powered up, the system is fully operational. To optimize the displayed image make any appropriate adjustments as described in this guide.
If any problems are encountered, verify that the cables are routed and connected properly, and that all display devices have suitable resolutions and refresh rates, and the image has been optimized as far as possible.
If your problems persist, call the Extron S3 Sales & Technical Support Hotline. See the contact numbers on the rear page of this guide for the Extron office nearest you.
PowerCage MTP T 15HD RSA and PowerCage MTP R 15HD RSA SEQ • Installation and Operation | 11 |