Board Setup and Operation
On the MTP T 15HD RSA board there are two DIP switches (switch #1 is for refresh rate, switch #2 is for
The factory set defaults for these are:
•DIP switch #1 is 60 Hz (down)
•DIP switch #2 is audio (down)
•EDID encoder is 1024x768 (position 2)
On the MTP R 15HD RSA SEQ board there are four active DIP switches. These are: switch #1 = Horizontal sync, switch #2 = Vertical sync, switch 3 =
The factory default settings for these are:
•DIP switch #1 is H– (down)
•DIP switch #2 is V– (down)
•DIP switch #3 is unidirectional
•DIP switch #4 is MTP compatible (down)
•DIP switch #5 and #6 not used (down)
For both boards, access to the DIP switches and encoder is via a
Alternatively, if changes are to be made after a board is installed, the board should be removed from the PowerCage by loosening the top and bottom retaining screws and carefully pulling the board out of its slot.
Changing the MTP T 15HD RSA Board Settings
1.Set the DIP switches as required.
Switch Position | Switch #1 Setting | Switch #2 Setting |
Up/On | 50 Hz | |
|
|
|
Down/Off (default) | 60 Hz | Audio |
|
|
|
O 1 | 2 |
N |
|
a.Select
b.Select the desired refresh rate.
2.Using a small screwdriver, rotate the encoder pointer to the number or letter corresponding to the resolution required.
See below for EDID encoder positions and resolutions:
Position | Resolution | Position | Resolution |
0 | N/A | 8 | 1366 x 768 |
|
|
|
|
1 | 800 x 600 | 9 | 1400 x 1050 |
|
|
|
|
2 | 1024 x 768 (default) | A | 1440 x 900 |
|
|
|
|
3 | 1280 x720 | B | 1600 x 1200 |
|
|
|
|
4 | 1280 x 768 | C | 1680 x 1050 |
|
|
|
|
5 | 1280 x 800 | D | 1920 x 1080 |
|
|
|
|
6 | 1280 x 1024 | E | 1920 x 1200 |
|
|
|
|
7 | 1360 x 768 | F | N/A |
PowerCage MTP T 15HD RSA and PowerCage MTP R 15HD RSA SEQ • Installation and Operation | 9 |