Extron electronic MTP 15HD RSA manual Installation Operation

Page 8

Installation and

Operation

This section describes the installation and operation of the PowerCage MTP T 15HD RSA and MTP R 15HD RSA SEQ, including:

Installing the Boards into the PowerCage Enclosure

Board Connections, LEDs, and Rear Panel Features

PowerCage Front Panel Port, Control, and Indicators

Board Setup and Operation

Installing the Boards into the PowerCage Enclosure

Up to 16 single slot or 8 dual slot input/output boards can be inserted into the PowerCage enclosure. The PowerCage MTP T 15HD RSA transmitters are single slot boards, and PowerCage MTP R 15HD RSA SEQ receivers are dual slot boards.

NOTES: The boards are hot-swappable; they can be installed or removed without turning off or disconnecting the power to the PowerCage enclosure.

CAUTION: Use ESD precautions when installing a board to avoid damaging the board. Keep the board in the anti-static bag until needed. Use proper grounding techniques during installation..

1.Where applicable, remove as many blank plates or previously installed boards from the rear of the PowerCage as necessary for the number of new boards to be installed.

2.Hold the board with the signal connectors towards you and the LED at the top, and align the top and bottom grooves of the board with the slide posts in the selected enclosure slot. See the example in figure 1.

16 Available Single Board Slots or

8 Double Board Slots

Power Supply

 

Tx Rx

 

1 2

FIBER

 

232-RS

TxRx

TxRx

REMOTE

RS-232

R

 

OVER

AUDIO L

 

OUTPUT

RGB

INPUT

 

Tx Rx

 

C

 

Align board and

slide into slot.

Tx Rx

1 2

FIBER

 

232-RS

TxRx

TxRx

REMOTE

RS-232

R

 

OVER

AUDIO L

 

Screws

 

OUTPUT

RGB

(2 per board)

 

 

 

Figure 1. Inserting Boards into the PowerCage Enclosure

PowerCage MTP T 15HD RSA and PowerCage MTP R 15HD RSA SEQ • Installation and Operation

4

Image 8
Contents PowerCage MTP 15HD RSA Series MTP Twisted Pair Transmitter and Receiver Modular BoardsSafety Instructions English Copyright Contents About this Guide About the PowerCage MTP 15HD RSA Transmitters and ReceiversIntroduction Features Page Installation Operation Installing the Boards into the PowerCage EnclosureBoard Connections, LEDs, and Rear Panel Features Audio connector 5-pole captive screwSee distance table on Maximum Transmission Distances for Analog Signals at 60 Hz PowerCage Front Panel Port, Control, and Indicators PowerCage Front PanelBoard Setup and Operation Changing the MTP T 15HD RSA Board SettingsSwitch Position Switch #1 Setting Switch #2 Setting Position ResolutionButton Function LED Color Skew, Level, and Peaking AdjustmentsFor Skew adjustment For Level Adjustment For Peaking AdjustmentResetting Skew Delay, Level and Peaking OperationSpecifications Video input PowerCage MTP T 15HD RSAVideo output PowerCage MTP R 15HD RSA SEQ Reference InformationSync PowerCage MTP T 15HD RSA, PowerCage MTP R 15HD RSA SEQ Audio input PowerCage MTP T 15HD RSAAudio output PowerCage MTP R 15HD RSA SEQ Control/RemoteGeneral MtbfPowerCage MTP 15HD RSA Part Numbers Cables and ConnectorsPart Numbers Included PartsUSA, Canada, South America Japan Central America Europe, Africa, and the Middle China EastAsia Middle East Europe