The transmitter board also features EDID emulation, whereby the correct refresh rate and resolution is applied to the incoming computer signal, ensuring a proper image output display.
Two DIP switches on the board allows the user to set the refresh rate to 50 or 60 Hz (default is 60 Hz) using switch #1. The second switch controls the
The resolution is selected by turning the
NOTE: The EDID encoder and DIP switch combination point to
information block to send to the RGB input. See the “Board Setup and
Operation” section for a table of settings, and details of how to access set the switches and encoder.
In addition, a toggle switch on the rear panel is available to turn the
The rear panel has an LED that lights green when power is applied to the board.
•PowerCage MTP R 15HD RSA SEQ receiver — This board supports RGB,
The input from a compatible MTP transmitter is made over twisted pair cabling via the
This board has a level, peaking, and skew adjustment feature. When adjustment is necessary, the selection between skew, level, and peaking is made via a recessed button.
The single digital encoder is used to adjust each individual setting (red skew, green skew, blue skew, level and peaking) as needed.
Four DIP switches on the board allow the user to set the horizontal sync (switch #1), vertical sync (switch #2), bi- or unidirectional
The rear panel also has an LED that lights green when power is applied to the board.
NOTE: For full operating details, see the “Installation and Operation” section, in this guide.
Features
•Modular,
•
•Supports RGBHV, RGBS, RGsB, RsGsBs, component video, composite video, and
•Compatible with HDTV component video,
•LED power indicator
•Compatible with all MTP products
PowerCage MTP T 15HD RSA and PowerCage MTP R 15HD RSA SEQ • Introduction | 2 |