Extron electronic manual DVS 150 Troubleshooting

Page 31

Problem	Cause	Solution
Picture controls are	Input 4 is selected.	Switch to input 1–3. Input 4 is
not active.		pass-through only (page 1-2).

The image is green.	The unit is	Turn off sync on green (page 2-6).
	configured for
	sync on green.

The image is too soft.	The detail level	Change the detail level (page 2-6).
	needs to be changed.

DVS 150 Troubleshooting

5-3

Image 31

Contents Digital Video Scaler DVSSicherheitsanleitungen Deutsch PrecautionsSafety Instructions English Consignes de Sécurité FrançaisQuick Start DVS InstallationConfiguring the Scaler Table of Contents Table of Contents, cont’d Introduction OneDVS 150 Introduction FeaturesIntroduction About the ScalerDVS 150 Introduction Introduction, cont’d Two InstallationDVS 150 Installation InstallationRear Panel Features InstallationMounting the scaler Installing the rubber feetCabling Installation, cont’dDVS 150 front panel Front Panel FeaturesConfiguration settings Configuring the ScalerDVS 150 Installation Installation, cont’d Operation ThreeFront Panel Operation Default screensAdjusting an image OperationChoosing the output rate Minimum, maximum, and default value screensSystem reset Freeze modeExecutive mode Channel resetSerial Communication FourDVS 150 Serial Communication Serial CommunicationRS-232 Programmer’s Guide DVS initiated messagesUsing the command/response table DVS error responseRemote Contact Closure Operation Serial Communication, cont’d Command/response tableControl Software for Windows Installing the softwareSignal Enhancement Products Control Program Using the softwareFive TroubleshootingOperating Problems TroubleshootingDVS 150 Troubleshooting DVS 150 Troubleshooting Troubleshooting, cont’d Reference Information AAppendixReference Information SpecificationsDVS 150 Reference Information BNC cables BNC-5 HR Cable Assorted connectors BNC ConnectorsPre-cut cables BNC-4 HR CableFCC Class B Notice Extron ELECTRONICS, Asia