Extron electronic DVS 150 manual Installation, cont’d, Cabling

Installation, cont’d

3.Place the rubber foot on one corner of the scaler, and press it into place.

Position the rubber foot carefully before pressing it into place. It is difficult to move the foot after it is in place.

4.Repeat steps 2 and 3 to install a rubber foot on each of the remaining corners of the scaler.

5.Turn the scaler right side up and place it in the desired location.

Cabling

The scaler can connect to input devices that produce composite video,

S-video, or component video, and it can connect to input devices that produce RGB video via the RGB pass-through connector. The scaler can connect to output devices such as LCD projectors, DLP displays, or plasma displays

To cable the scaler, complete the following steps. Use figure 4 as a general guide.

1.Attach the input device (or devices) to the scaler. Figure 3 shows each of the

connection options.

VID	B-Y		VID	B-Y		VID	B-Y
1			1			1
R-Y	Y		R-Y	Y		R-Y	Y
	2	3		2	3		2	3	RGB
Composite Video			Component Video			S-video			Pass-Thru
(Input 1)			(Input 2)			(Input 3)			(Input 4)

Figure 3 — Input connections

You can attach up to three input devices, one each of composite video, S-video, and component video. You can also connect an RGB input device for pass- through to the output. You can select among the input sources via the input selection switch on the front panel.

If there is no video input, the LCD displays “No Source”.

DVS 150

100-240 VAC .3A MAX

50/60 Hz

VIDEO	INPUTS		OUTPUTS	REMOTE
	B-Y	R	G	B
1		RGB
R-Y	S-VIDEO	PASS-THRU	V	RGB
	Y	H		S

2 3 4

			RS-232 Control
		DLP Projector
DVD Player
	or		or
Laserdisc Player
	HDTV Plasma	LCD Projector	CRT Projector
DSS Receiver		OUTPUT
Laptop
Computer	INPUT

Figure 4 — Cabling the scaler

2.Use BNC connectors or a 15-pin HD connector to connect the scaler to the output device. Figure 5 shows each of the connection options.

R	G	B	R	G	B	R	G	B
H	V	S	H	V	S	H	V	S
	RGsB			RGBS			RGBHV

Figure 5 — Output connections

RGB Output

If you cable the scaler for sync on green (RGsB or SOG) output, you must also configure the scaler for SOG via the configuration menu. See “Configuring the Scaler” on page 2-6 for instructions.

2-4 DVS 150 Installation