Mounting the scaler

Use the LCD menu screens to configure the scaler. See “Configuring the Scaler” on page 2-6.

The image from the input device should appear on the output device. If it does not, double check steps 3 and 4 and make adjustments as needed, and then see “Operating Problems” on page 5-2.

Each DVS 150 ships with four uninstalled rubber feet. If you are going to rack mount the unit, do so before cabling it, and do not install the rubber feet. If you are not rack mounting the scaler, skip to “Installing the rubber feet” below.

The DVS 150 can be rack mounted using one side of an optional 19” 1U Universal Rack Shelf (Extron part # 60-190-01).

To rack mount the scaler, do the following:

1.If rubber feet were previously installed on the bottom of the case, remove them.

2.Mount the scaler on the rack shelf as shown in figure 2. Use two

4-40 x 1/8” screws in opposite (diagonal) corners to secure the case to the shelf.

Faulse Front panel uses 2 front holes

INPUT

1 2 3

4 COLOR TINT

BRIT
CONTRAST	H
	SHIFT

VSHIFT

RATE
DIGITAL	DVS		100
	VIDEO		100
		SCALER

(2) 4-40 x 1/8" Screws

Use 2 mounting holes on opposite corners

Figure 2 — Mounting the scaler

Installing the rubber feet

The scaler ships with four uninstalled rubber feet. Install the rubber feet only if you are not rack mounting the scaler. To install the rubber feet, do the following:

1.Turn the scaler upside down and place it on a flat surface.

2.Remove the protective backing from a rubber foot.

DVS 150 Installation

2-3