2.Turn the adjustment knob until the desired adjustment is accomplished. The LCD returns to the default screens, and the adjusted value is saved for future use by the active input, if you press the same button again or if you stop turning the knob for eight seconds.
If an image control reaches its minimum, maximum, or default level, the LCD displays a screen similar to the screens shown in figure 9.
COLOR
Min
COLOR
Max
COLOR
Default
Figure 9 — Minimum, maximum, and default value screens
If input 4 (RGB
Color control button — Adjusts the color intensity.
Tint control button — Adjusts the amount of tint displayed. This adjustment is not available if the input is component video.
Brightness control button — Adjusts the amount or intensity of video light produced on the screen, without regard to color.
Contrast control button — Adjusts the range of light and dark values in a picture, or the ratio between the maximum and the minimum brightness values.
Horizontal shift control button — Shifts the image to the left and right.
Vertical shift control button — Shifts the image up and down.
Choosing the output rate
If input 4 (RGB
To choose the output rate, do the following:
1.Refer to the documentation that accompanied the display device to determine its native mode (or sweet spot).
2.Press and hold the rate button on the scaler for two seconds. The LED above the button lights, and the LCD displays the current output resolution and frequency.
3.Turn the adjustment knob until the desired output rate appears in the LCD and the image is displayed at the correct rate.
Available rates are:
• 640 x 480, 60 Hz | • | 640 x 480, 75 Hz | |
• | 800 x 600, 60 Hz | • 800 x 600, 75 Hz | |
• | 832 x 624, 60 Hz | • | 832 x 624, 75 Hz |
•848 x 480, 60 Hz
• 852 x 480, 60 Hz | • 852 x 480, 75 Hz | ||
• | 1024 x 768, 60 Hz | • | 1024 x 768, 75 Hz |
• | 1280 x 768, 56 Hz | • | 1280 x 1024, 60 Hz |
•1360 x 765, 60 Hz
•HDTV 480p
•HDTV 720p
•HDTV 1080p
DVS 150 Operation |