Extron electronic SW YUV A, SW RGB Installation, cont’d, Under furniture mounting the switcher

Page 14

Installation, cont’d

Under furniture mounting the switcher

The SW2 switcher models can be mounted under a table or other horizontal surface with an optional Extron under-desk mounting kit (part #70-077-01). The SW4 and SW6 switcher models can be mounted under a table or other horizontal surface with an optional Extron 1U under-desk mounting kit (part #70-222-01).

SW2 models

1.	Secure the optional under-desk mounting brackets to the switcher with the six
	machine screws provided in the mounting kit (figure 2-3).
2.	Hold the switcher with attached brackets against the underside of the desk or
	other furniture. Mark the location of holes for screws on the desk.

AUTO	SWICH
ACUTIVE

1

2

R	S
	GBHV & AUW2
	DIO RGBHVSW
	ITCHER

Under Desk Kit

Figure 2-3 — Under-desk mounting

3.	Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
	desk at the marked screw locations from the underside/inside (concealed
	side) of the furniture, where the switcher will be located.
4.	Insert the four wood screws into the pilot holes. Fasten each screw into the
	installation surface until just less than 1/4" of the screw head protrudes.
5.	Align the installed screws with the slots in the mounting brackets, and place
	the switcher against the surface, with the screws through the bracket slots.
6.	Slide the switcher slightly forward or back, then tighten all four screws to
	fasten it in place.
SW4 and SW6 models
1.	Secure the optional table/wall mounting brackets to the switcher with the
	eight machine screws provided in the mounting kit (figure 2-2).
2.	Hold the switcher with attached brackets against the underside of the desk or
	other furniture. Mark the location of holes for screws on the underside of the
	desk.

2-4 SW RGB and YUV A Switchers • Installation

Image 14

Contents Wideband and Component Video and Audio Switchers SW RGB and SW YUV a SeriesSicherheitsanleitungen Deutsch Safety Instructions EnglishConsignes de Sécurité Français Instrucciones de seguridad EspañolQuick Start SW RGB and YUV a Switchers SW RGB and YUV a Switchers Quick Start QS-1Switch inputs in normal switch mode Quick Start SW RGB and YUV a Switchers, cont’dSwitch mode QS-2 SW RGB and YUV a Switchers Quick StartTable of Contents Table of Contents, cont’d One Introductiontroduction, cont’d About the SwitchersSW RGB and YUV a Switchers Introduction All switchers FeaturesAudio switching models RGB video modelsIntroduction, cont’d All modelsTwo Mounting the Switcher Installationstallation, cont’dInstallation Overview Rack mounting the switcherRack mounting an SW2 switcher Installation, cont’d Under furniture mounting the switcherThrough furniture mounting the switcher Through-desk mountingSW2 Rgbhv video switcher Cabling and Rear Panel ViewsInputs RGB and component video inputsOutput RGB and component video outputsPower connection Remote connectionInstallation, cont’d Three SW RGB and YUV a Switchers Operation Controls and IndicatorsInput selection controls and indicators Operationeration, cont’dAudio controls and indicators Autoswitch mode control and indicatorSwitching inputs Switcher OperationsPower Operation, cont’dExample Adjusting the audio level Example Viewing the audio levelExample, step D Adjusting the audio level Optimizing the Audio SW2, SW4, and SW6 Rgbhv a only Audio level reset single inputAudio level reset all inputs MemoryTroubleshooting If No Image Appears Four RemoteControl,cont’d Host-to-switcher instructionsSW RGB and YUV a Switchers Remote Control Simple Instruction SetTimeout Switcher-initiated unsolicited messagesError responses Using the command/response tableCommand Ascii Command Response Additional description Remote Control, cont’dSymbol definitions Reset Windows-Based Control Program Installing the softwareUsing the software Contact Closure Infrared Remote ControlUsing the help system Remote Control, cont’d Specifications and Part Numbers AAppendix aSpecificationsecifications, cont’d SW RGB and YUV a Switchers Specifications and Part NumbersSync Specifications, cont’d Audio output SW 2/4/6 Rgbhv a onlyOptional accessories SW Rgbhv switcher part numbersSupplied accessories Part NumbersBNC-5 RC and BNC-6 RC Cable Assorted connectors BNC connectorsPlenum BNC-5 Mini HR Cable Pre-cut cablesFCC Class a Notice Extron’s Warranty Extron Electronics, USA