Extron electronic SW YUV A, SW RGB manual Troubleshooting If No Image Appears

Page 28

Operation, cont’d

Troubleshooting — If No Image Appears

1.	Ensure that all devices are plugged in and powered on. The switcher is
	receiving power if the front panel Power LED (if equipped) is lit.
2.	Ensure an active input is selected on the switcher or that the switcher is in
	autoswitch mode.
3.	Ensure that the proper signal format is supplied.
4.	Check the cabling and make corrections as necessary.
5.	Call the Extron S3 Sales & Technical Support Hotline if necessary.

3-8 SW RGB and YUV A Switchers • Operation

Image 28

Contents Wideband and Component Video and Audio Switchers SW RGB and SW YUV a SeriesSafety Instructions English Consignes de Sécurité FrançaisSicherheitsanleitungen Deutsch Instrucciones de seguridad EspañolQuick Start SW RGB and YUV a Switchers SW RGB and YUV a Switchers Quick Start QS-1Quick Start SW RGB and YUV a Switchers, cont’d Switch modeSwitch inputs in normal switch mode QS-2 SW RGB and YUV a Switchers Quick StartTable of Contents Table of Contents, cont’d One SW RGB and YUV a Switchers Introduction About the SwitchersIntroductiontroduction, cont’d Features Audio switching modelsAll switchers RGB video modelsIntroduction, cont’d All modelsTwo Installationstallation, cont’d Installation OverviewMounting the Switcher Rack mounting the switcherRack mounting an SW2 switcher Installation, cont’d Under furniture mounting the switcherThrough furniture mounting the switcher Through-desk mountingSW2 Rgbhv video switcher Cabling and Rear Panel ViewsInputs RGB and component video inputsOutput RGB and component video outputsPower connection Remote connectionInstallation, cont’d Three Controls and Indicators Input selection controls and indicatorsSW RGB and YUV a Switchers Operation Operationeration, cont’dAudio controls and indicators Autoswitch mode control and indicatorSwitcher Operations PowerSwitching inputs Operation, cont’dExample Adjusting the audio level Example Viewing the audio levelExample, step D Adjusting the audio level Audio level reset single input Audio level reset all inputsOptimizing the Audio SW2, SW4, and SW6 Rgbhv a only MemoryTroubleshooting If No Image Appears Four Host-to-switcher instructions SW RGB and YUV a Switchers Remote ControlRemoteControl,cont’d Simple Instruction SetSwitcher-initiated unsolicited messages Error responsesTimeout Using the command/response tableSymbol definitions Remote Control, cont’dCommand Ascii Command Response Additional description Reset Using the software Installing the softwareWindows-Based Control Program Using the help system Infrared Remote ControlContact Closure Remote Control, cont’d Specifications and Part Numbers AAppendix aSpecificationsecifications, cont’d SW RGB and YUV a Switchers Specifications and Part NumbersSync Specifications, cont’d Audio output SW 2/4/6 Rgbhv a onlySW Rgbhv switcher part numbers Supplied accessoriesOptional accessories Part NumbersAssorted connectors BNC connectors Plenum BNC-5 Mini HR CableBNC-5 RC and BNC-6 RC Cable Pre-cut cablesFCC Class a Notice Extron’s Warranty Extron Electronics, USA