Extron electronic SW YUV A, SW RGB manual Windows-Based Control Program, Installing the software

Page 34

Remote Control, cont’d

Windows-Based Control Program

The Universal Switcher Control Program, part #29-031-01, is compatible with MicrosSoft Windows 3.1, 3.11, 95/98, and above, and provides remote control of the following:

•Input selection (including audio breakaway for models with video and audio)

•Audio gain and attenuation adjustments (audio models)

Updates to this program can be downloaded from the Extron Web site (http://www.extron.com).

Installing the software

The program is contained on a single 3.5” diskette and can be run from the floppy drive, or it can be installed and run from the hard drive.

To install the software on the hard drive, run setup.exe from the floppy disk and follow the screen instructions.

By default, the Windows installation creates a C:\UNIVSW folder and places two icons (Universal Switcher Control Program and Universal Switcher Help) into a group named “Extron Electronics”.

Using the software

1.	Connect a serial cable between a PC and the switcher’s remote port. The
	cable’s pin assignments are shown in figure 4-1 on page 4-2. Power up the PC
	and the switcher.
2.	To run the software, click on Start>Programs>Extron Electronics>Universal
	Switcher Control Pgm.

3.	Click on the COM port that is connected to the switcher’s RS-232 port.
4.	The Extron Universal Switcher Control Program window (Figure 4-2) displays
	the input signal status for each input (signal present or not present), the
	selected input, and the audio gain for the selected input.

Figure 4-2 — Universal Switcher program window

indicates that the input signal is present and is selected.

indicates that the input signal is present but not selected.

indicates that the input signal is not present.

Click the button to refresh the input signal status information.

4-6 SW RGB and YUV A Switchers • Remote Control

Image 34

Contents Wideband and Component Video and Audio Switchers SW RGB and SW YUV a SeriesSicherheitsanleitungen Deutsch Safety Instructions EnglishConsignes de Sécurité Français Instrucciones de seguridad EspañolQuick Start SW RGB and YUV a Switchers SW RGB and YUV a Switchers Quick Start QS-1Switch inputs in normal switch mode Quick Start SW RGB and YUV a Switchers, cont’dSwitch mode QS-2 SW RGB and YUV a Switchers Quick StartTable of Contents Table of Contents, cont’d One SW RGB and YUV a Switchers Introduction About the SwitchersIntroductiontroduction, cont’d All switchers FeaturesAudio switching models RGB video modelsIntroduction, cont’d All modelsTwo Mounting the Switcher Installationstallation, cont’dInstallation Overview Rack mounting the switcherRack mounting an SW2 switcher Installation, cont’d Under furniture mounting the switcherThrough furniture mounting the switcher Through-desk mountingSW2 Rgbhv video switcher Cabling and Rear Panel ViewsInputs RGB and component video inputsOutput RGB and component video outputsPower connection Remote connectionInstallation, cont’d Three SW RGB and YUV a Switchers Operation Controls and IndicatorsInput selection controls and indicators Operationeration, cont’dAudio controls and indicators Autoswitch mode control and indicatorSwitching inputs Switcher OperationsPower Operation, cont’dExample Adjusting the audio level Example Viewing the audio levelExample, step D Adjusting the audio level Optimizing the Audio SW2, SW4, and SW6 Rgbhv a only Audio level reset single inputAudio level reset all inputs MemoryTroubleshooting If No Image Appears Four RemoteControl,cont’d Host-to-switcher instructionsSW RGB and YUV a Switchers Remote Control Simple Instruction SetTimeout Switcher-initiated unsolicited messagesError responses Using the command/response tableSymbol definitions Remote Control, cont’dCommand Ascii Command Response Additional description Reset Using the software Installing the softwareWindows-Based Control Program Using the help system Infrared Remote ControlContact Closure Remote Control, cont’d Specifications and Part Numbers AAppendix aSpecificationsecifications, cont’d SW RGB and YUV a Switchers Specifications and Part NumbersSync Specifications, cont’d Audio output SW 2/4/6 Rgbhv a onlyOptional accessories SW Rgbhv switcher part numbersSupplied accessories Part NumbersBNC-5 RC and BNC-6 RC Cable Assorted connectors BNC connectorsPlenum BNC-5 Mini HR Cable Pre-cut cablesFCC Class a Notice Extron’s Warranty Extron Electronics, USA