Extron electronic SW RGB, SW YUV A manual Sync

Page 39

Sync

Input type

RGBHV (except SW6 YUV A), RGBS, RGsB, RsGsBs

Output type

RGBHV (except SW6 YUV A), RGBS, RGsB, RsGsBs

Input level

Analog or TTL, 0.5V to 5.0V p-p

Output level

5.0V p-p, unterminated, for V output; H output follows input

Input impedance

510 ohms for V input and unselected H input; the selected H input

 

impedance is determined by the device connected to the H output.

Output impedance

75 ohms for V output; the H output impedance is determined by the device

 

connected to the selected H input.

Max input voltage

5.0V p-p

Max. propagation delay

35 ns

Max. rise/fall time

4 ns

Polarity

Positive or negative (follows input)

Audio — SW 2/4/6 RGBHV A only

Gain

Adjustable

 

When audio gain is set to unity (0 dB), balanced output will have a 0 dB

 

gain; unbalanced output will be attenuated by 6 dB.

Frequency response

20 Hz to 20 kHz, ±0.05 dB

THD + Noise

0.03% @ 1 kHz, 0.3% @ 20 kHz at nominal level

S/N

>90 dB at rated maximum output

Crosstalk

<-65 dB @ 20 kHz, <-80 dB @ 1 kHz or below 60 Hz

Stereo channel separation

>80 dB @ 20 Hz to 20 kHz

CMRR

>75 dB @ _20 Hz to 20 kHz

Digital audio

Input type

Dolby Digital, DTS, AES/EBU

Output type

Dolby Digital, DTS, AES/EBU

Bandwidth

100 MHz (-3 dB)

Sampling rates

32, 44.1, 48, 96 kHz

Input level

0.5V to 5.0V p-p

Output level

2.5V p-p (when terminated with 75 ohms)

Input impedance

510 ohms for unselected inputs; for the selected input, impedance is

 

determined by the device connected to the output

Output impedance

Determined bythe device connected to the selected input

Max input voltage

5.0V p-p

Max. propagation delay

35 ns

Max. rise/fall time

4 ns

Audio input — SW 2/4/6 RGBHV A only

Number/signal type

2, 4, or 6 (depending on the model) stereo, balanced/unbalanced

Connectors

2, 4, or 6 (depending on the model) 3.5 mm captive screw connectors, 5 pole

Impedance

>10 kohms unbalanced, 20 kohms balanced, DC coupled

Nominal level

-20 dBV (100mV), -10 dBV (316mV), 0 dBu (1V), or +4 dBu (1.23V),

 

configurable

Maximum level

+20 dBu, (balanced or unbalanced) at 1%THD+N

Input gain adjustment

-24 dB to +18 dB, adjustable per input

SW RGB and YUV A Switchers • Specifications and Part Numbers A-3

Image 39
Contents SW RGB and SW YUV a Series Wideband and Component Video and Audio SwitchersInstrucciones de seguridad Español Safety Instructions EnglishConsignes de Sécurité Français Sicherheitsanleitungen DeutschSW RGB and YUV a Switchers Quick Start QS-1 Quick Start SW RGB and YUV a SwitchersQS-2 SW RGB and YUV a Switchers Quick Start Quick Start SW RGB and YUV a Switchers, cont’dSwitch mode Switch inputs in normal switch modeTable of Contents Table of Contents, cont’d One About the Switchers SW RGB and YUV a Switchers IntroductionIntroductiontroduction, cont’d RGB video models FeaturesAudio switching models All switchersAll models Introduction, cont’dTwo Rack mounting the switcher Installationstallation, cont’dInstallation Overview Mounting the SwitcherRack mounting an SW2 switcher Under furniture mounting the switcher Installation, cont’dThrough-desk mounting Through furniture mounting the switcherCabling and Rear Panel Views SW2 Rgbhv video switcherRGB and component video inputs InputsRGB and component video outputs OutputRemote connection Power connectionInstallation, cont’d Three Operationeration, cont’d Controls and IndicatorsInput selection controls and indicators SW RGB and YUV a Switchers OperationAutoswitch mode control and indicator Audio controls and indicatorsOperation, cont’d Switcher OperationsPower Switching inputsExample Viewing the audio level Example Adjusting the audio levelExample, step D Adjusting the audio level Memory Audio level reset single inputAudio level reset all inputs Optimizing the Audio SW2, SW4, and SW6 Rgbhv a onlyTroubleshooting If No Image Appears Four Simple Instruction Set Host-to-switcher instructionsSW RGB and YUV a Switchers Remote Control RemoteControl,cont’dUsing the command/response table Switcher-initiated unsolicited messagesError responses TimeoutRemote Control, cont’d Symbol definitionsCommand Ascii Command Response Additional description Reset Installing the software Using the softwareWindows-Based Control Program Infrared Remote Control Using the help systemContact Closure Remote Control, cont’d AAppendix a Specifications and Part NumbersSW RGB and YUV a Switchers Specifications and Part Numbers Specificationsecifications, cont’dSync Audio output SW 2/4/6 Rgbhv a only Specifications, cont’dPart Numbers SW Rgbhv switcher part numbersSupplied accessories Optional accessoriesPre-cut cables Assorted connectors BNC connectorsPlenum BNC-5 Mini HR Cable BNC-5 RC and BNC-6 RC CableFCC Class a Notice Extron’s Warranty Extron Electronics, USA